MSM8916 海信M9模块学习记录三：开机按键、音量上下按键

设计原理图：

引脚说明：

PIN No.	Pin Value	IO Votage	MSM’s	Tye	Functional description
PIN030	PIN (KEY_PWR_ON)	开机键	-	DI	Keypad poweron detect input
PIN031	PIN (KEY_PM_RESIN)	下键	-	“DO-ZDO”	PMU_KEY
PIN032	PIN (KEY_VOL_UP)	上键	GPIO107	B-PD:nppukp	Configurable I/O

1、主要初始化函数位置：

/ptboce/bootable/bootloader/lk/target/M9PLUS_10/init.c

主要代码：

#include <dev/keys.h>
#define TLMM_VOL_UP_BTN_GPIO    107
/* Return 1 if vol_up pressed */
int target_volume_up()    //按键上初始化代码
{
    uint8_t status = 0;

    gpio_tlmm_config(TLMM_VOL_UP_BTN_GPIO, 0, GPIO_INPUT, GPIO_PULL_UP, GPIO_2MA, GPIO_ENABLE);

    /* Wait for the gpio config to take effect - debounce time */
    thread_sleep(10);

    /* Get status of GPIO */
    status = gpio_status(TLMM_VOL_UP_BTN_GPIO);

    /* Active low signal. */
    return !status;
}
/* Return 1 if vol_down pressed */
uint32_t target_volume_down() //按键下初始化代码
{
    /* Volume down button tied in with PMIC RESIN. */
    return pm8x41_resin_status();
}

#if FEATURE_HS_BOOT_SYSTEM_HS
/* Return 1 if pwr pressed */
uint32_t target_pwr_key() //开关按键初始化代码
{
    /* Volume down button tied in with PMIC RESIN. */
    return pm8x41_get_pwrkey_is_pressed();
}
#endif

static void target_keystatus()  //按键总初始化代码
{
    keys_init();

    if(target_volume_down())
        keys_post_event(KEY_VOLUMEDOWN, 1);

    if(target_volume_up())
        keys_post_event(KEY_VOLUMEUP, 1);
#if FEATURE_HS_BOOT_SYSTEM_HS
    if(target_pwr_key())
        keys_post_event(KEY_PWR, 1);
#endif
}

次要代码：

/ptboce/bootable/bootloader/lk/dev/keys/keys.c

static unsigned long key_bitmap[BITMAP_NUM_WORDS(MAX_KEYS)];

void keys_init(void)
{
    memset(key_bitmap, 0, sizeof(key_bitmap));
}

从初始化代码上看，开关按键和音量下键是M9源码中默认的，不需要去重新定义和配置，直接调用封装好的函数初始化就好了。二音量上键，需要定义一下（GPIO107），并初始化。

2、主要外部调用函数

/bootable/bootloader/lk/dev/pmic/pm8916/pm8916.c
/bootable/bootloader/lk/dev/pmic/pm8916/include/pm8916.h

uint8_t pm_get_power_on_status(void)
uint32_t pm_get_chg_voltage()

参考学习：
https://blog.csdn.net/eliot_shao/article/details/53836216