解决wrap_content的模版代码

    @Override
    /**
     * 解决的方法总结：
     * 1、指定一个默认的内部宽高，例如本方法中的desiredWidth = 100。
     * 2、判断当MeasureSpec的模式为AT_MOST(对应于wrap_content)时，设置结果为设置的值（最大为我们设置的值，如果小于设置值就设置为specSize）。
     * 3、判断当MeasureSpec的模式为非AT_MOST时，直接设置为系统的测量值即可。
     * 4、设置值没有特定的标准，以实际情况为准。
     */
    protected void onMeasure(int widthMeasureSpec, int heightMeasureSpec) {

        int desiredWidth = 100;
        int desiredHeight = 100;

        int widthMode = MeasureSpec.getMode(widthMeasureSpec);
        int widthSize = MeasureSpec.getSize(widthMeasureSpec);
        int heightMode = MeasureSpec.getMode(heightMeasureSpec);
        int heightSize = MeasureSpec.getSize(heightMeasureSpec);

        int width;
        int height;

        //Measure Width
        if (widthMode == MeasureSpec.EXACTLY) {
            //Must be this size
            width = widthSize;
        } else if (widthMode == MeasureSpec.AT_MOST) {
            //Can't be bigger than...
            width = Math.min(desiredWidth, widthSize);
        } else {
            //Be whatever you want
            width = desiredWidth;
        }

        //Measure Height
        if (heightMode == MeasureSpec.EXACTLY) {
            //Must be this size
            height = heightSize;
        } else if (heightMode == MeasureSpec.AT_MOST) {
            //Can't be bigger than...
            height = Math.min(desiredHeight, heightSize);
        } else {
            //Be whatever you want
            height = desiredHeight;
        }

        //MUST CALL THIS
        setMeasuredDimension(width, height);
    }