rabbitMQ 错误处理

com.rabbitmq.client.ShutdownSignalException

错误

Exception in thread "main" java.io.IOException
	at com.rabbitmq.client.impl.AMQChannel.wrap(AMQChannel.java:126)
	at com.rabbitmq.client.impl.AMQChannel.wrap(AMQChannel.java:122)
	at com.rabbitmq.client.impl.AMQChannel.exnWrappingRpc(AMQChannel.java:144)
	at com.rabbitmq.client.impl.AMQConnection.start(AMQConnection.java:401)
	at com.rabbitmq.client.impl.recovery.RecoveryAwareAMQConnectionFactory.newConnection(RecoveryAwareAMQConnectionFactory.java:64)
	at com.rabbitmq.client.impl.recovery.AutorecoveringConnection.init(AutorecoveringConnection.java:156)
	at com.rabbitmq.client.ConnectionFactory.newConnection(ConnectionFactory.java:1095)
	at com.rabbitmq.client.ConnectionFactory.newConnection(ConnectionFactory.java:1054)
	at com.rabbitmq.client.ConnectionFactory.newConnection(ConnectionFactory.java:1012)
	at com.rabbitmq.client.ConnectionFactory.newConnection(ConnectionFactory.java:1170)
	at com.zy.one.RabbitProducer.main(RabbitProducer.java:33)
Caused by: com.rabbitmq.client.ShutdownSignalException: connection error; protocol method: #method<connection.close>(reply-code=530, reply-text=NOT_ALLOWED - vhost / not found, class-id=10, method-id=40)
	at com.rabbitmq.utility.ValueOrException.getValue(ValueOrException.java:66)
	at com.rabbitmq.utility.BlockingValueOrException.uninterruptibleGetValue(BlockingValueOrException.java:36)
	at com.rabbitmq.client.impl.AMQChannel$BlockingRpcContinuation.getReply(AMQChannel.java:494)
	at com.rabbitmq.client.impl.AMQChannel.privateRpc(AMQChannel.java:288)
	at com.rabbitmq.client.impl.AMQChannel.exnWrappingRpc(AMQChannel.java:138)
	... 8 more
Disconnected from the target VM, address: '127.0.0.1:53862', transport: 'socket'

解决方法

1. 首先判断服务器对应的5672端口是否开放

firewall-cmd --zone=public --add-port=5672/tcp --permanent   # 开放5672端口

firewall-cmd --zone=public --remove-port=5672/tcp --permanent  #关闭5672端口

firewall-cmd --reload   # 配置立即生效

开放端口时报错

systemctl status firewalld查看firewalld状态

发现当前是dead状态，即防火墙未开启
通过systemctl start firewalld开启防火墙，没有任何提示即开启成功。

再次firewalld状态，显示running即已开启了。

关闭防火墙设置

systemctl stop firewalld

查看防火墙所有开放的端口

firewall-cmd --zone=public --list-ports

关闭防火墙

如果要开放的端口太多，嫌麻烦，可以关闭防火墙，安全性自行评估

systemctl stop firewalld.service

查看防火墙状态

 firewall-cmd --state

配置完成之后需要重启docker服务

systemctl restart docker

否则会产生异常

2. rabbitMQ 对应的管理界面进行设置
3.