RK3188 触摸屏调试（基于radxa rock）

使用Goodix 的GT801进行调试

1、内核配置

选中GT801

2、修改相应的PIN脚定义

修改的相关文件：

/kernel/arch/arm/mach-rk30/board-rk30-box.c

根据硬件的实际情况配置,主要改动 RESET ,PWR, IRQ 引脚

#if defined(CONFIG_TOUCHSCREEN_GT8XX)
#define TOUCH_RESET_PIN  RK30_PIN4_PD0     //根据硬件的实际情况去配置
#define TOUCH_PWR_PIN    INVALID_GPIO      //根据硬件的实际情况去配置
int goodix_init_platform_hw(void)
{
   ...
}

#ifdef CONFIG_I2C2_RK30
static struct i2c_board_info __initdata i2c2_info[] = {
#if defined (CONFIG_TOUCHSCREEN_GT8XX)
        {
                .type          = "Goodix-TS",  
                .addr          = 0x55,
                .flags         = 0,
                .irq           = RK30_PIN4_PC2, //根据实际情况去配置
                .platform_data = &goodix_info,
        },
#endif

3、kernel/drivers/input/touchscreen/Makefile

看这个配置对应的驱动文件

obj-$(CONFIG_D70_L3188A)                += goodix_touch.o
obj-$(CONFIG_TOUCHSCREEN_GT8XX)                += rk29_i2c_goodix.o

从上面看到GT8XX 对应的驱动文件是 rk29_i2C_goodix.c

4、kernel/drivers/input/touchscreen/rk29_i2c_goodix.c

static struct i2c_driver rk_ts_driver = {
        .probe          = rk_ts_probe,
        .remove         = rk_ts_remove,
        .shutdown       = rk_ts_shutdown,
#ifndef CONFIG_HAS_EARLYSUSPEND
        .suspend        = rk_ts_suspend,
        .resume         = rk_ts_resume,
#endif
        .id_table       = goodix_ts_id,
        .driver = {
                .name   = "Goodix-TS",  //此处的名字和<span style="font-family: 微软雅黑; font-size: 14px;">board-rk30-box.c中的type要保持一致</span>
                .owner = THIS_MODULE,
        },
};