mini2440 u-boot linux 内核启动,mini2440通过NFS启动的U-Boot参数设置

// 编译内核

cd /home/guoqian/4-3-1/linux-2.6.29

make disclean

cp config-mini2440 .config

make menuconfig ARCH=arm

make uImage ARCH=arm CROSS_COMPILE=arm-linux-

// 将uImage拷至TFTP

cp arch/arm/boot/uImage /tftpboot/

// u-boot参数设置

set ipaddr 192.168.1.230

set serverip 192.168.1.123

set gatewayip 192.168.1.1

set bootcmd 'tftp 31000000 uImage; bootm 31000000'

set bootargs 'root=/dev/nfs rw nfsroot=192.168.1.123:/nfsroot/rootfs ip=192.168.1.230 console=ttySAC0 mem=64M'

save

printenv

启动过程如下：

U-Boot 2010.03 ( 4鏈18 2010 - 21:39:25)

modified by tekkamanninja (tekkamanninja@163.com)

Love Linux forever!!

I2C:   ready

DRAM:  64 MB

Flash:  2 MB

NAND:  256 MiB

Video: 240x320x16 20kHz 62Hz

In:    serial

Out:   serial

Err:   serial

USB slave is enable!

Net:   dm9000

U-Boot 2010.03 ( 4鏈18 2010 - 21:39:25)

modified by tekkamanninja

(tekkamanninja@163.com)

Love Linux forever!!

Hit any key to stop autoboot:  0

dm9000 i/o: 0x20000300, id: 0x90000a46

DM9000: running in 16 bit mode

MAC: 08:08:11:18:12:27

operating at 100M full duplex mode

Using dm9000 device

TFTP from server 192.168.1.123; our IP address is 192.168.1.230

Filename 'uImage-nfs'.

Load address: 0x31000000

Loading: T #################################################################

#################################################################

#########################

done

Bytes transferred = 2274308 (22b404 hex)

## Booting kernel from Legacy Image at 31000000 ...

Image Name:   Linux-2.6.32.2-FriendlyARM

Created:      2011-08-19   2:45:31 UTC

Image Type:   ARM Linux Kernel Image (uncompressed)

Data Size:    2274244 Bytes =  2.2 MB

Load Address: 30008000

Entry Point:  30008000

Verifying Checksum ... OK

Loading Kernel Image ... OK

OK

Starting kernel ...

Uncompressing Linux................................................................................................................................................... done, booting the kernel.

Linux version 2.6.32.2-FriendlyARM (root@ShiGuang) (gcc version 4.4.3 (ctng-1.6.1) ) #2 Fri Aug 19 10:45:24 CST 2011

CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0007177

CPU: VIVT data cache, VIVT instruction cache

Machine: FriendlyARM Mini2440 development board

Memory policy: ECC disabled, Data cache writeback

CPU S3C2440A (id 0x32440001)

S3C24XX Clocks, (c) 2004 Simtec Electronics

S3C244X: core 405.000 MHz, memory 101.250 MHz, peripheral 50.625 MHz

CLOCK: Slow mode (1.500 MHz), fast, MPLL on, UPLL on

Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256

Kernel command line: root=/dev/nfs rw nfsroot=192.168.1.123:/nfsroot/rootfs ip=192.168.1.230 console=ttySAC0 mem=64M

PID hash table entries: 256 (order: -2, 1024 bytes)

Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)

Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)

Memory: 64MB = 64MB total

Memory: 60084KB available (4188K code, 451K data, 156K init, 0K highmem)

SLUB: Genslabs=11, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1

Hierarchical RCU implementation.

NR_IRQS:85

irq: clearing pending status 02000000

irq: clearing subpending status 00000002

Console: colour dummy device 80x30

console [ttySAC0] enabled

Calibrating delay loop... 201.93 BogoMIPS (lpj=504832)

Mount-cache hash table entries: 512

CPU: Testing write buffer coherency: ok

NET: Registered protocol family 16

S3C2440: Initialising architecture

S3C2440: IRQ Support

S3C24XX DMA Driver, (c) 2003-2004,2006 Simtec Electronics

DMA channel 0 at c4808000, irq 33

DMA channel 1 at c4808040, irq 34

DMA channel 2 at c4808080, irq 35

DMA channel 3 at c48080c0, irq 36

S3C244X: Clock Support, DVS off

bio: create slab at 0

SCSI subsystem initialized

……

……

……

TCP cubic registered

NET: Registered protocol family 17

s3c2410-rtc s3c2410-rtc: hctosys: invalid date/time

eth0: link down

IP-Config: Guessing netmask 255.255.255.0

IP-Config: Complete:

device=eth0, addr=192.168.1.230, mask=255.255.255.0, gw=255.255.255.255,

host=192.168.1.230, domain=, nis-domain=(none),

bootserver=255.255.255.255, rootserver=192.168.1.123, rootpath=

Looking up port of RPC 100003/2 on 192.168.1.123

eth0: link up, 100Mbps, full-duplex, lpa 0x45E1

Looking up port of RPC 100005/1 on 192.168.1.123

VFS: Mounted root (nfs filesystem) on device 0:11.

Freeing init memory: 156K

hwclock: settimeofday() failed: Invalid argument

Try to bring eth0 interface up......NFS root ...Done

Please press Enter to activate this console.

[root@FriendlyARM /]#

[root@FriendlyARM /]#

[root@FriendlyARM /]#