TI的TMS320C6713B芯片手册提到，IPD和IPU分别代表内部下拉和上拉电阻。为了反对这些信号引脚上的电源电压，建议使用不超过4.4kΩ和2.0kΩ的外部上拉或下拉电阻。在复位时，若引脚同时路由并被三态或未驱动，推荐采用10kΩ的外部电阻来维持IPU/IPD状态。这两段话并不矛盾，分别针对不同情况下的电阻选择建议。
1)tms320c6713b芯片手册48页中有一段备注：
‡ IPD = Internal pulldown, IPU = Internal pullup. [To oppose the supply rail on these IPD/IPU signal pins, use external pullup or pulldown resistors no greater than 4.4 kΩ and 2.0 kΩ, respectively.]
请问To oppose the supply rail on these IPD/IPU signal pins具体什么意思？是防止电源干扰的意思吗？
2)‡ IPD = Internal pulldown, IPU = Internal pullup. [To oppose the supply rail on these IPD/IPU signal pins, use external pullup or pulldown resistors no greater than 4.4 kΩ and 2.0 kΩ, respectively.]
§ To ensure a proper logic level during reset when these pins are both routed out and 3−stated or not driven, it is recommended to include an external 10 kΩ pullup/pulldown resistor to sustain the IPU/IPD, respectively.
上面两段话中我理解意思是一个要求上下拉电阻应不大于4.4 kΩ和2.0 kΩ，另一段要求上下拉电阻应为10 kΩ，这两段话是否相互矛盾？
请各位专家帮忙解答下，非常感谢！
扫一扫
1911
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
