Simulink cannot solve the algebraic loop containing 'rectifier1/dq conversion1/Product4' at time 0.099975461132453064 using the TrustRegion-based algorithm due to one of the following reasons: the model is ill-defined i.e., the system equations do not have a solution; or the nonlinear equation solver failed to converge due to numerical issues.
To rule out solver convergence as the cause of this error, either
a) switch to LineSearch-based algorithm using
set_param('rectifier1','AlgebraicLoopSolver','LineSearch')
b) reducing the ode23t solver RelTol parameter so that the solver takes smaller time steps.
If the error persists in spite of the above changes, then the model is likely ill-defined and requires modification.
这是什么原因呢，
1309
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
