stm32里toggle_stm32实现按键功能 新手求助

展开全部

你说的应该是按键触发外部中断的功能吧？

如果是继续往下看：stm32实现功能都是一62616964757a686964616fe58685e5aeb931333363393664个套路配置你所用按键的引脚的GPIO和中断(我这里是以PA0引脚为例,用时候修改为你的引脚)

void EXTI_PA0_Config(void)

{

GPIO_InitTypeDef GPIO_InitStructure;

EXTI_InitTypeDef EXTI_InitStructure;

NVIC_InitTypeDef NVIC_InitStructure;

/* config the extiline clock and AFIO clock */

RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA | RCC_APB2Periph_AFIO, ENABLE);

/* config the NVIC */

NVIC_PriorityGroupConfig(NVIC_PriorityGroup_1);

/* 配置中断源 */

NVIC_InitStructure.NVIC_IRQChannel = EXTI0_IRQn;

NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 0;

NVIC_InitStructure.NVIC_IRQChannelSubPriority = 0;

NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;

NVIC_Init(&NVIC_InitStructure); NVIC_Configuration();

/* EXTI line gpio config*/

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_0;

GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IPU; // 上拉输入

GPIO_Init(GPIOA, &GPIO_InitStructure);

/* EXTI line mode config */

GPIO_EXTILineConfig(GPIO_PortSourceGPIOA, GPIO_PinSource0);

EXTI_InitStructure.EXTI_Line = EXTI_Line0;

EXTI_InitStructure.EXTI_Mode = EXTI_Mode_Interrupt;

EXTI_InitStructure.EXTI_Trigger = EXTI_Trigger_Falling;

//下降沿中断

EXTI_InitStructure.EXTI_LineCmd = ENABLE;

EXTI_Init(&EXTI_InitStructure);

}

2.经过以上配置,当外部按键中断触发时就会执行,stm32f10x_it.c中的,对应外部中断函数,此时把你需要进行的操作加入函数中(比如点亮熄灭led)

void EXTI0_IRQHandler(void)

{

if (EXTI_GetITStatus(EXTI_Line0) != RESET) {

//确保是否产生了 EXTI Line 中断

// LED1 取反

LED1_TOGGLE;//这里需要改为你要实现的功能,

EXTI_ClearITPendingBit(EXTI_Line0);

//清除中断标志位

}

}