1.Refer to the exhibit. A network technician is troubleshooting a connectivity problem . R2. The technician enters the show cdp neighbors command at the R2 console. If the network is composed .ly of Cisco devices, for which devices should entries be displayed?<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" />

A.R1
B.SW-B and R<?xml:namespace prefix = st1 ns = "urn:schemas-microsoft-com:office:smarttags" />1
C.SW-B, R1, and SW-C
D.R3, SW-B, R1, and SW-C
E.SW-A, R3, SW-B, R1, and SW-C
F.Host A, SW-A, R3, SW-B, R1, and SW-C
Correct:B
2.Refer to the exhibit. What can be determined from the output shown?

A.The JaxSwitch1 switch is using VTP.
B.This is the .ly switch in the LAN topology.
C.The JaxSwitch1 switch is not the root switch.
D.The link to the root bridge is through a 1 Gbps connection.
E.Spanning Tree Protocol is disabled . the JaxSwitch1 switch.
Correct:C
3.What are the general recommendations regarding the placement of access control lists? (Choose two.)
A.Standard ACLs should be placed as close as possible to the source of traffic to be denied.
B.Extended ACLs should be placed as close as possible to the source of traffic to be denied .
C.Standard ACLs should be placed as close as possible to the destination of traffic to be denied .
D.Extended ACLs should be placed as close as possible to the destination of traffic to be denied .
Correct:B C
4.Drag Drop

Correct:
Green choice5---->Yellow Choice1
Green choice2---->Yellow Choice2
Green choice1---->Yellow Choice3
Green choice6---->Yellow Choice4
Green choice3---->Yellow Choice5
5.Refer to the graphic. Which of the following commands would create the output shown at the bottom of the graphic?

A.Router# show ip eigrp topology
B.Router# show ip route
C.Router# show ip eigrp neighbors
D.Router# show ip ospf route
E.Router# show ip ospf database
Correct:A
6.LAB

Correct:
7.Drag Drop

Correct:
Green choice1---->Yellow Choice5
Green choice2---->Yellow Choice3
Green choice3---->Yellow Choice1
Green choice4---->Yellow Choice6
Green choice5---->Yellow Choice4
Green choice6---->Yellow Choice2
8.Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational?
A.frame-relay arp
B.frame-relay map
C.frame-relay interface-dlci
D.frame-relay lmi-type
Correct:B
9.Refer to the exhibit. What can be determined about the interfaces of the Main_Campus router from the output shown?

A.The LAN interfaces are configured . different subnets.
B.Interface FastEthernet 0/0 is configured as a trunk.
C.The Layer 2 protocol of interface Serial 0/1 is NOT operational.
D.The router is a modular router with five FastEthernet interfaces.
E.Interface FastEthernet 0/0 is administratively deactivated.
Correct:B
10.Refer to the graphic. It has been decided that Workstation 1 should be denied access to Server1. Which of the following commands are required to prevent .ly Workstation 1 from accessing Server1 while allowing all other traffic to flow normally? (Choose two.)

A.RouterA(config)# interface fa0/0 RouterA(config-if)# ip access-group 101 out
B.RouterA(config)# interface fa0/0 RouterA(config-if)# ip access-group 101 in
C.RouterA(config)# access-list 101 deny ip host 172.16.161.150 host 172.16.162.163 RouterA(config)# access-list 101 permit ip any any
D.RouterA(config)# access-list 101 deny ip 172.16.161.150 0.0.0.255 172.16.162.163 0.0.0.0 RouterA(config)# access-list 101 permit ip any any
Correct:B C
11.Refer to the exhibit. Which two devices can be used to complete the connection between the WAN router at the customer site and the service provider? (Choose two.)

A.CSU/DSU
B.modem
C.WAN switch
D.ATM switch
E.Frame Relay switch
F.ISDN TA
Correct:A B
12.Drag Drop

Correct:
Green choice10---->Yellow Choice1
Green choice1---->Yellow Choice2
Green choice6---->Yellow Choice3
Green choice3---->Yellow Choice4
Green choice7---->Yellow Choice5
13.Refer to the exhibit. Host A is to send data to Host B. How will Router1 handle the data frame received from Host A? (Choose three.)

A.Router1 will strip off the source MAC address and replace it with the MAC address . the forwarding FastEthernet interface.
B.Router1 will strip off the source IP address and replace it with the IP address . the forwarding FastEthernet interface.
C.Router1 will strip off the destination MAC address and replace it with the MAC address of Host B.
D.Router1 will strip off the destination IP address and replace it with the IP address of Host B.
E.Router1 will forward the data frame out interface FastEthernet0/1.
F.Router1 will forward the data frame out interface FastEthernet0/2.
Correct:A C F
14.Why has the network shown in the exhibit failed to converge?

A.The no auto-summary command needs to be applied to the routers.
B.The network numbers have not been properly configured . the routers.
C.The subnet masks for the network numbers have not been properly configured.
D.The autonomous system number has not been properly configured.
E.The bandwidth values have not been properly configured . the serial interfaces.
Correct:A
15.Refer to the partial command output shown. Which two statements are correct regarding the router hardware? (Choose two.)

A.Total RAM size is 32 KB.
B.Total RAM size is 16384 KB (16 MB).
C.Total RAM size is 65536 KB (64 MB).
D.Flash size is 32 KB.
E.Flash size is 16384 KB (16 MB).
F.Flash size is 65536 KB (64 MB).
Correct:C E
16.Refer to the exhibit. R1 can ping across the serial link to 172.168.10.5, but cannot ping the FastEthernet interface of R2 (172.168.10.65). The routing protocol being used is EIGRP, and the routing table of R2 is shown. Which two statements could causes of this problem? (Choose two.)

A.The serial interface does not have the clockrate set.
B.EIGRP is not enabled . .e of the routers.
C.The IP addressing scheme has overlapping subnetworks.
D.The IP addressing scheme is using subnet zero but the ip subnet-zero command has not been enabled . .e or both of the routers.
E.The FastEthernet interface of R2 is administratively shutdown.
F.The EIGRP autonomous system numbers configured . the two routers do not match.
Correct:B F
17.If all OSPF routers in a single area are configured with the same priority value, what value does a router use for the OSPF router ID in the absence of a loopback interface?
A.the IP address of the first Fast Ethernet interface
B.the IP address of the console management interface
C.the highest IP address among its active interfaces
D.the lowest IP address among its active interfaces
E.the priority value until a loopback interface is configured
Correct:C
18.To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? (Choose two.)
A.Each end of the trunk line must be set to IEEE 802.1E encapsulation.
B.The VTP management domain name of both switches must be set the same.
C.All ports . both the switches must be set as access ports.
D.One of the two switches must be configured as a VTP server.
E.A rollover cable is required to connect the two switches together.
F.A router must be used to forward VTP traffic between VLANs.
Correct:B D
19.Assuming .ly .e VLAN in the exhibit, which switch is acting as the root bridge?

A.Switch1
B.Switch2
C.Switch3
D.A root bridge is not required in this network.
Correct:C
20.If an ethernet port . a router was assigned an IP address of 172.16.112.1/20, what is the maximum number of hosts allowed . this subnet?
A.1024
B.2046
C.4094
D.4096
E.8190
Correct:C
21.Refer to the exhibit. The network administrator wants to prevent computers . the 192.168.23.64/26 subnet from accessing the 192.168.23.128/26 subnet via FTP. All other hosts should be allowed access. What commands should be entered . the router to accomplish this task?

A.Router(config)#access-list 101 deny tcp 192.168.23.64 0.0.0.63 192.168.23.128 0.0.0.63 eq ftp Router(config)#access-list 101 permit ip any any Router(config)#interface fa0/0 Router(config-if)#ip access-group 101 in
B.Router(config)#access-list 101 deny tcp 192.168.23.64 0.0.0.255 192.168.23.128 0.0.0.255 eq ftp Router(config)#access-list 101 permit ip any any Router(config)#interface fa0/0 Router(config-if)#ip access-group 101 in
C.Router(config)#access-list 101 deny tcp 192.168.23.64 0.0.0.63 192.168.23.128 0.0.0.63 eq ftp Router(config)#access-list 101 permit ip any any Router(config)#interface fa0/0 Router(config-if)#access-list 101 out
D.Router(config)#access-list 101 deny tcp 192.168.23.64 0.0.0.255 192.168.23.128 0.0.0.255 eq ftp Router(config)#access-list 101 permit ip any any Router(config)#interface fa0/1 Router(config-if)#ip access-group 101 in
E.Router(config)#access-list 101 deny tcp 192.168.23.128 0.0.0.63 192.168.23.64 0.0.0.63 eq ftp Router(config)#access-list 101 permit ip any any Router(config)#interface fa0/1 Router(config-if)#ip access-group 101 in
F.Router(config)#access-list 101 deny tcp 192.168.23.128 0.0.0.255 192.168.23.128 0.0.0.255 eq ftp Router(config)#access-list 101 permit ip any any Router(config)#interface fa0/1 Router(config-if)#ip access-group 101 out
Correct:A
22.A technician is investigating a problem with the exhibited network. These symptoms have been observed: - None of the user hosts can access the Internet. - None of the user hosts can access the server in VLAN 9. - Host A can ping Host B. - Host A CANNOT ping Host C or Host D. - Host C can ping Host D. What could cause the symptoms?

A.Interface S0/0 . the router is down.
B.Interface Fa1/0 . the router is down.
C.Interface Fa0/5 . Switch3 is down.
D.Interface Fa0/4 . Switch3 is down.
E.Switch 1 is turned off.
F.Switch 3 is turned off.
Correct:B
23.Which address represents a unicast address?
A.224.1.5.2
B.FFFF.FFFF.FFFF
C.192.168.24.59/30
D.255.255.255.255
E.172.31.128.255/18
Correct:E
24.How does replacing a hub with a switch affect CSMA/CD behavior in an Ethernet network?
A.It effectively eliminates collisions.
B.In increases the size of the collision domain by allowing more devices to be connected at .ce.
C.It decreases the amount of time that a jam signal must be sent to reach all network devices.
D.It reduces the total amount of bandwidth available to each device.
E.It eliminates Layer 3 broadcast traffic.
Correct:A
25.Access list 1 has been written to allow host 172.16.1.224 access to the router vty lines. What command would assign this access list to the virtual terminal lines?
A.router(config-line)# ip access-group 1 in
B.router(config-line)# access-class 1 in
C.router(config-line)# ip access-list 1 in
D.router(config-line)# access-line 1 in
Correct:B
26.A Catalyst 2950 needs to be reconfigured. What steps will ensure that the old configuration is erased? (Choose three.)
A.Erase flash.
B.Restart the switch.
C.Delete the VLAN database.
D.Erase the running configuration.
E.Erase the startup configuration.
F.Modify the configuration register.
Correct:B C E
27.Refer to the exhibit. Switch-1 needs to send data to a host with a MAC address of 00b0.d056.efa4. What will Switch-1 do with this data?

A.Switch-1 will drop the data because it does not have an entry for that MAC address.
B.Switch-1 will flood the data out all of its ports except the port from which the data originated.
C.Switch-1 will send an ARP request out all its ports except the port from which the data originated.
D.Switch-1 will forward the data to its default gateway.
Correct:B
28.The command ip route 192.168.24.64 255.255.255.192 192.168.8.2 100 was configured . a router named Corporate. No routing protocols or other static routes are configured . the Corporate router yet. Which statement is true about this command?
A.This command sets a gateway of last resort for the Corporate router.
B.The number 100 indicates the number of hops to the destination network.
C.The interface with IP address 192.168.8.2 is . the Corporate router.
D.The command creates a static route for all IP traffic with the source address 192.168.24.64.
E.Packets destined for host 192.168.24.124 will be sent to 192.168.8.2.
Correct:E
29.Refer to the exhibit. Why does the switch have two MAC addresses assigned to the FastEthernet 0/1 port in the switch address table?

A.Data from two of the devices connected to the switch has been sent to Host3.
B.Data from Host3 and Host4 has been received by switch port FastEthernet 0/1.
C.Either Host3 or Host4 has just had the NIC replaced.
D.Host3 and Host4 are . two different VLANs.
Correct:B
30.The network administrator has configured NAT as shown in the graphic. Some clients can access the Internet while others cannot. What should the network administrator do to resolve this problem?

A.Configure an IP NAT pool.
B.Properly configure the ACL.
C.Apply the ACL to the S0 interface.
D.Configure another interface with the ip nat outside command.
Correct:B