VLAN configuration on linux

root@ubuntu:/etc/apt# vconfig
Expecting argc to be 3-5, inclusive. Was: 1

Usage: add [interface-name] [vlan_id]
rem [vlan-name]
set_flag [interface-name] [flag-num] [0 | 1]
set_egress_map [vlan-name] [skb_priority] [vlan_qos]
set_ingress_map [vlan-name] [skb_priority] [vlan_qos]
set_name_type [name-type]

* The [interface-name] is the name of the ethernet card that hosts
the VLAN you are talking about.
* The vlan_id is the identifier (0-4095) of the VLAN you are operating on.
* skb_priority is the priority in the socket buffer (sk_buff).
* vlan_qos is the 3 bit priority in the VLAN header
* name-type: VLAN_PLUS_VID (vlan0005), VLAN_PLUS_VID_NO_PAD (vlan5),
DEV_PLUS_VID (eth0.0005), DEV_PLUS_VID_NO_PAD (eth0.5)
* FLAGS: 1 REORDER_HDR When this is set, the VLAN device will move the
ethernet header around to make it look exactly like a real
ethernet device. This may help programs such as DHCPd which
read the raw ethernet packet and make assumptions about the
location of bytes. If you don't need it, don't turn it on, because
there will be at least a small performance degradation. Default
is OFF.

转载于:https://www.cnblogs.com/abacuspix/archive/2012/09/17/2689845.html