etherchannel配置

手动配置etherchannel
S1
interface port-channel 1
exit
interface range gigabitEthernet 0/1-2
channel-group 1 mode on
switchport trunk encapsulaition dot1q
switchport mode trunk 
exit
 
port-channel load-balance dst-ip
 
S2
 
interface port-channel 2 两边的编号可以不一样，只是本地有效而已
exit
 
interface range gigabitEthernet 0/1-2
channel-group 2 mode on
switchport trunk encapsulation dot1q
switchport mode trunk
exit
 
port-channnel load-balance dst-ip
 
 
配置pagp 和lacp
 
S1
interface port-channel 1
exit
interface range gigabitEthernet 0/1-2
channel-procotol pagp
channel-group 1 mode desirable
switchport trunk encapsulaiton dot1q
switchport mode trunk  
 
interface port-channel 2
exit
 
interface range gigabitEthernet 0/1-2
channel-procotol pagp
channel-group 2 mode auto 
switchport trunk encapsulation dot1q
switchport mode trunk 
 
实验调试
show etherchannel summary
Switch#show etherchannel summary 
Flags:  D - down        P - in port-channel
        I - stand-alone s - suspended
        H - Hot-standby (LACP only)
        R - Layer3      S - Layer2
        U - in use      f - failed to allocate aggregator
        u - unsuitable for bundling
        w - waiting to be aggregated
        d - default port
 
 
Number of channel-groups in use: 1
Number of aggregators:           1
 
Group  Port-channel  Protocol    Ports
------+-------------+-----------+----------------------------------------------
 
1      Po1(SU)           PAgP   Gig0/1(P) Gig0/2(P) 
 
show etherchannel prot-channel
 
Switch#show etherchannel port-channel
                Channel-group listing:
                ----------------------
 
Group: 1
----------
                Port-channels in the group:
                ---------------------------
 
Port-channel: Po1
------------
 
Age of the Port-channel   = 00d:00h:20m:19s
Logical slot/port   = 2/1       Number of ports = 2
GC                  = 0x00000000      HotStandBy port = null
Port state          = Port-channel 
Protocol            =   PAGP
Port Security       = Disabled
 
Ports in the Port-channel:
 
Index   Load   Port     EC state        No of bits
------+------+------+------------------+-----------
  0     00     Gig0/2   Desirable-Sl       0
  0     00     Gig0/1   Desirable-Sl       0
Time since last port bundled:    00d:00h:17m:41s    Gig0/1
 
附件：
Switch(config-if-range)#channel-group 1 mode ?
  active     Enable LACP unconditionally
  auto       Enable PAgP only if a PAgP device is detected
  desirable  Enable PAgP unconditionally
  on         Enable Etherchannel only
  passive    Enable LACP only if a LACP device is detected
 
Switch(config-if-range)#channel-protocol ?
  lacp  Prepare interface for LACP protocol
  pagp  Prepare interface for PAgP protocol