配置链路聚合

链路聚合是将两个或更多数据信道结合成 个单个的信道，该信道以 个单个的更高 带宽的逻辑链路出现。链路聚合一般用来连接一个或多个带宽需求大的设备，其实质 是将两台设备间的数条物理链路“组合“成逻辑上的一条数据通路，称为一条聚合链路 AP1。该链路在逻辑上是一个整体。

 

首先对左边的switch2交换机进行配置

Switch#
Switch#config t
Enter configuration commands, one per line.  End with CNTL/Z.
Switch(config)#interface range f0/1-2
Switch(config-if-range)#channel-group 1 mode des
Switch(config-if-range)#channel-group 1 mode desirable       #给接口加入一个AP，desirable主动发起表白
Switch(config-if-range)#
Creating a port-channel interface Port-channel 1

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/2, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/2, changed state to up

Switch(config-if-range)#end
Switch#
%SYS-5-CONFIG_I: Configured from console by console

%LINK-5-CHANGED: Interface Port-channel 1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface Port-channel 1, changed state to up

配置switch3

Switch>
Switch>en 
Switch#config t
Enter configuration commands, one per line.  End with CNTL/Z.
Switch(config)#interface range f0/1-2

Switch(config-if-range)#channel-group 1 mode auto          #auto被动接受，一个发起一个接受，建立聚合
Switch(config-if-range)#
Creating a port-channel interface Port-channel 1

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/2, changed state to down

%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/2, changed state to up

%LINK-5-CHANGED: Interface Port-channel 1, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface Port-channel 1, changed state to up

Switch(config-if-range)#
Switch(config-if-range)#end
Switch#
%SYS-5-CONFIG_I: Configured from console by console

Switch#