PAP的简单实现

仅简单记录了一下自己使用dynamips模拟器，在CISCO 3620中配置PAP的过程！

注意：以下仅为Router1的配置，Router2的配置和Router1的配置极其类似！

Router#enable

Router#configure teminal
  ^
% Invalid input detected at '^' marker.

Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname Router1
Router1(config)#aaa new-model
Router1(config)#aaa authentication login default local
Router1(config)#username router1 password 0 router1
Router1(config)#interface serial 0/0
Router1(config-if)#encapsulation ppp
Router1(config-if)#clock rate 64000
Router1(config-if)#ip address 192.168.1.1 255.255.255.0
Router1(config-if)#ppp authentication pap
AAA: Warning, authentication list "default" is not defined for PPP.

Router1(config-if)#ppp pap sent-user router2 password 0 router2
Router1(config-if)#no shut
Router1(config-if)#
00:06:04: %LINK-3-UPDOWN: Interface Serial0/0, changed state to up
Router1(config-if)#^Z
Router1#write
00:07:35: %SYS-5-CONFIG_I: Configured from console by console
Building configuration...
[OK]
Router1#
00:11:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up
Router1#ping 192.168.1.2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 16/76/220 ms
Router1#write
Building configuration...
[OK]

Router1#  

本文转自tiancong 51CTO博客，原文链接:http://blog.51cto.com/tiancong/159854