Linux485协议文件夹,Linux c使用485通讯，ioctl的配置

/* Include definition for RS485 ioctls: TIOCGRS485 and TIOCSRS485 */

#include /* Open your specific device (e.g., /dev/mydevice): */

int fd = open ("/dev/mydevice", O_RDWR);

if (fd < 0) {

/* Error handling. See errno. */

}

struct serial_rs485 rs485conf;

/* Enable RS485 mode: */

rs485conf.flags |= SER_RS485_ENABLED;

/* Set logical level for RTS pin equal to 1 when sending: */

rs485conf.flags |= SER_RS485_RTS_ON_SEND;

/* or, set logical level for RTS pin equal to 0 when sending: */

rs485conf.flags &= ~(SER_RS485_RTS_ON_SEND);

/* Set logical level for RTS pin equal to 1 after sending: */

rs485conf.flags |= SER_RS485_RTS_AFTER_SEND;

/* or, set logical level for RTS pin equal to 0 after sending: */

rs485conf.flags &= ~(SER_RS485_RTS_AFTER_SEND);

/* Set rts delay before send, if needed: */

rs485conf.delay_rts_before_send = ...;

/* Set rts delay after send, if needed: */

rs485conf.delay_rts_after_send = ...;

/* Set this flag if you want to receive data even whilst sending data */

rs485conf.flags |= SER_RS485_RX_DURING_TX;

if (ioctl (fd, TIOCSRS485, &rs485conf) < 0) {

/* Error handling. See errno. */

}

/* Use read() and write() syscalls here... */

/* Close the device when finished: */

if (close (fd) < 0) {

/* Error handling. See errno. */

}