matlab wavedemo,s12x_demo_CW，matlab的一个demo

matlab的一个demo 需要用2009打开

If you would like to change the exisTIng derivaTIve with a different one，

you have to consider following points：

- You will need to adapt the CodeWarrior project setTIngs： In the ‘Assembler for

HC12’ and ‘Compiler for HC12’ panels make sure that the new CPU will be used

in the ‘Command Line Arguments’：

- HC12： -CpuHC12

- HCS12： -CpuHCS12

- HCS12X： -CpuHCS12X

- The derivaTIve header and source files are located in the following directories：

- {CodeWarrior}lib\hc12c\include (derivative header files)

- {CodeWarrior}lib\hc12c\src (derivative source files)

You will need to drag and drop from the directories above the new derivative

header and source files to the ‘Libraries’ group.

HINT： To open a ‘Windows Explorer’ where the file is located：

Use the context menu/right mouse click on

the derivative header/source file in the ‘Libraries’ project folder

and select ‘Open in Windows Explorer’。

- You can now remove the derivative header and source files that are referenced

by the wizard from the project. Remove the derivative header and source files

in the ‘Libraries’ group： context menu/right mouse click on the derivative header

and source files in the ‘Libraries’ group and select ‘Remove’。

- You will need to adapt the main source file. This file can be found in the

‘Sources’ group. Open this file and change the name of the included

derivative header file to the new one. In case of a C/C++ project you will

also need to adapt the pragma ‘LINK_INFO DERIVATIVE’ to the new derivative.

This pragma tells the simulator which derivative to simulate. However you can

also remove this pragma and setup the new derivative in the HI-WAVE debugger

itself (see next point)。

- You will need to adapt the PRM file as well. PRM files are located in the

following directory：

- {CodeWarrior}lib\hc12c\prm

You need to open the new PRM file and copy & past the content to your currently

used PRM file. In case you don not have a banked memory model， you will need to

adapt the content as well. You may have a look at the existing prm file.

- After successful compilation and linkage you can start the HI-WAVE debugger.

You will need to setup the debugger for the new derivative.

- For the Full Chip Simulation\Simulator Connection：

Use the ‘Set Derivative.。.’ dialog by using the menu option

‘Simulator’ 》 ‘Set Derivative.。.’。 In the opened dialog box you can

select the new derivative. The names used there might also be used

with the pragma ‘LINK_INFO DERIVATIVE’。

- For the P&E Multilink/Cyclone Pro Connection：

Use the ‘Set Derivative.。.’ dialog by using the menu option

‘MultilinkCyclonePro’ 》 ‘Set Derivative.。.’。 In the opened dialog box you can

select the new derivative.

- For the SofTec HCS12 Connection：

Use the ‘MCU Configuration’ dialog by using the menu option

‘inDART-HCS12’ 》 ‘MCU Configuration’。 In the opened dialog box you can

select the new derivative.

- For the HCS12 Serial Monitor target：

The derivative is determined automatically from the connected hardware.

However， the debugger might still display a list of parts where a thinner

selection between silicons from the same family should be done.

- Now you should have a project for the new derivative.