问题:
交换机S5700与防火墙USG5500无法对接Eth-trunk LACP-static模式,两端正常配置后,端口状态显示错误,Eth-trunk端口无法up 。
问题描述:
交换机侧 GE0/0/5和GE 0/0/6 组成Eth-trunk3 通过LACP-static与防火墙对接;防火墙侧采用端口GE0/0/1和GE0/0/2组成Eth-trunk1通过LACP-static与交换机对接。
交换机侧配置:
interface Eth-Trunk3
port link-type trunk
undo port trunk allow-pass vlan 1
port trunk allow-pass vlan 301 321
mode lacp-static
#
interface GigabitEthernet0/0/5
eth-trunk 3
#
interface GigabitEthernet0/0/6
eth-trunk 3
#
防火墙侧的配置:
interface Eth-Trunk1
alias Eth-Trunk1
mode lacp-static
#interface GigabitEthernet0/0/1
undo enable snmp trap updown physic-status
eth-trunk 1
lacp peer-portno 0002
#
interface GigabitEthernet0/0/2
undo enable snmp trap updown physic-status
eth-trunk 1
lacp peer-portno 0003
#
交换机侧端口状态显示:
单独查看物理端口,其物理状态UP;
[Ser-9306-1]disp interface GigabitEthernet 0/0/5
GigabitEthernet0/0/5 current state : UP
Line protocol current state : UP
Description:
Switch Port, TPID : 8100(Hex), The Maximum Frame Length is 9216
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 4c1f-cc99-5ec3
Last physical up time : 2014-02-26 16:29 UTC-08:00
Last physical down time : 2014-02-26 16:29 UTC-08:00
Current system time: 2014-02-26 16:29-08:00
Hardware address is 4c1f-cc99-5ec3
Last 300 seconds input rate 0 bytes/sec, 0 packets/sec
Last 300 seconds output rate