linux 千兆 路由器,ubuntu – 无法在Linux上设置NIC以建立千兆链路

我有一个Ubuntu 11.10 64位(实际上是两个,但只有一个连接)英特尔82578千兆网卡,它工作在100 Mbps,我希望它工作在1000 Mbps,但我不能.我怎么能找出什么是错的？

这是当我尝试使用ethtool设置速度时会发生什么：

# ethtool -s eth0 speed 1000

Cannot advertise speed 1000

我也试过这个并丢失了网络连接：

# ethtool -s eth0 speed 1000 duplex full

我的想法已经不多了.

一些信息：

服务器连接到Cisco RVS4000路由器,该路由器的所有活动端口均配置为使用自动协商的@ 1000 Mbps全双工.实际上,还有另一台服务器连接到路由器的另一个端口,工作正常,速度为1000 Mbps.

有关我遇到问题的服务器的信息：

lshw：

# lshw -C network

*-network

description: Ethernet interface

product: 82578DM Gigabit Network Connection

vendor: Intel Corporation

physical id: 19

bus info: pci@0000:00:19.0

logical name: eth0

version: 05

serial: 00:1e:67:15:2b:f1

size: 100Mbit/s

capacity: 1Gbit/s

width: 32 bits

clock: 33MHz

capabilities: pm msi bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation

configuration: autonegotiation=on broadcast=yes driver=e1000e driverversion=1.3.10-k2 duplex=full firmware=0.10-2 ip=192.168.1.12 latency=0 link=yes multicast=yes port=twisted pair speed=100Mbit/s

resources: irq:45 memory:b1a00000-b1a1ffff memory:b1a24000-b1a24fff ioport:2020(size=32)

*-network

description: Ethernet interface

product: 82574L Gigabit Network Connection

vendor: Intel Corporation

physical id: 0

bus info: pci@0000:03:00.0

logical name: eth1

version: 00

serial: 00:1e:67:15:2b:f0

capacity: 1Gbit/s

width: 32 bits

clock: 33MHz

capabilities: pm msi pciexpress msix bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation

configuration: autonegotiation=on broadcast=yes driver=e1000e driverversion=1.3.10-k2 firmware=1.9-0 latency=0 link=no multicast=yes port=twisted pair

resources: irq:16 memory:b1900000-b191ffff ioport:1000(size=32) memory:b1920000-b1923fff

ethtool的

# ethtool eth0

Settings for eth0:

Supported ports: [ TP ]

Supported link modes: 10baseT/Half 10baseT/Full

100baseT/Half 100baseT/Full

1000baseT/Full

Supports auto-negotiation: Yes

Advertised link modes: 10baseT/Half 10baseT/Full

100baseT/Half 100baseT/Full

1000baseT/Full

Advertised pause frame use: No

Advertised auto-negotiation: Yes

Speed: 100Mb/s

Duplex: Full

Port: Twisted Pair

PHYAD: 2

Transceiver: internal

Auto-negotiation: on

MDI-X: on

Supports Wake-on: pumbg

Wake-on: g

Current message level: 0x00000001 (1)

drv

Link detected: yes

dmesg有关网络驱动程序的信息：

# dmesg |grep e1000e

[ 1.938726] e1000e: Intel(R) PRO/1000 Network Driver - 1.3.10-k2

[ 1.938729] e1000e: Copyright(c) 1999 - 2011 Intel Corporation.

[ 1.938764] e1000e 0000:00:19.0: PCI INT A -> GSI 16 (level,low) -> IRQ 16

[ 1.938775] e1000e 0000:00:19.0: setting latency timer to 64

[ 1.938878] e1000e 0000:00:19.0: irq 45 for MSI/MSI-X

[ 2.181735] e1000e 0000:00:19.0: eth0: (PCI Express:2.5GT/s:Width x1) 00:1e:67:15:2b:f1

[ 2.181737] e1000e 0000:00:19.0: eth0: Intel(R) PRO/1000 Network Connection

[ 2.181771] e1000e 0000:00:19.0: eth0: MAC: 9,PHY: 9,PBA No: 0310FF-0FF

[ 2.181785] e1000e 0000:03:00.0: Disabling ASPM L0s

[ 2.181799] e1000e 0000:03:00.0: PCI INT A -> GSI 16 (level,low) -> IRQ 16

[ 2.181816] e1000e 0000:03:00.0: setting latency timer to 64

[ 2.182046] e1000e 0000:03:00.0: irq 46 for MSI/MSI-X

[ 2.182050] e1000e 0000:03:00.0: irq 47 for MSI/MSI-X

[ 2.182053] e1000e 0000:03:00.0: irq 48 for MSI/MSI-X

[ 2.293669] e1000e 0000:03:00.0: eth1: (PCI Express:2.5GT/s:Width x1) 00:1e:67:15:2b:f0

[ 2.293672] e1000e 0000:03:00.0: eth1: Intel(R) PRO/1000 Network Connection

[ 2.293754] e1000e 0000:03:00.0: eth1: MAC: 3,PHY: 8,PBA No: 1010FF-0FF

[ 15.316964] e1000e 0000:00:19.0: irq 45 for MSI/MSI-X

[ 15.372707] e1000e 0000:00:19.0: irq 45 for MSI/MSI-X

[ 19.897407] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex,Flow Control: Rx

[ 19.897412] e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO