I have tried the same process on Ubuntu! Also tried the rkdeveloptool to
erase it. Nothing has worked.
The documentation mentions RK3399_Android7.1_EraseIDB.7z but I cannot
find it to download. I have found a link to the Erase_IDB on the Baidu
site. But I cannot create a login and I cannot read the language. The
device will not load any firmware.
Here is the output from running the upgrade_tool on Linux:
gha@ubuntu:~/firefly-rk3399/u34/Linux_Upgrade_Tool/Linux_Upgrade_Tool$
sudo ./upgrade_tool ef FIREFLY-RK3399-UBUNTU18.04-GPT-20200714-1510.img
Program Data in /home/gha/.config/upgrade_tool
Loading loader...
Erase flash ok.
gha@ubuntu:~/firefly-rk3399/u34/Linux_Upgrade_Tool/Linux_Upgrade_Tool$
sudo ./upgrade_tool uf FIREFLY-RK3399-UBUNTU18.04-GPT-20200714-1510.img
Program Data in /home/gha/.config/upgrade_tool
Loading firmware...
Support Type:RK330C FW Ver:8.1.40 FW Time:2020-07-14 15:11:41
Loader ver:1.19 Loader Time:2020-07-14 15:10:09
Prepare IDB Fail
Here is the serial UART Debug output during the above. Note: I have to
power off/on the RK3399 after the erase (EF) in order for the UF comand
to proceed to the IDB failure.
DDR Version 1.22 20190506
In
Channel 0: DDR3, 800MHz
Bus Width=32 Col=10 Bank=8 Row=15/15 CS=2 Die Bus-Width=16 Size=2048MB
Channel 1: DDR3, 800MHz
Bus Width=32 Col=10 Bank=8 Row=15/15 CS=2 Die Bus-Width=16 Size=2048MB
256B stride
ch 0 ddrconfig = 0x101, ddrsize = 0x2020
ch 1 ddrconfig = 0x101, ddrsize = 0x2020
pmugrf_os_reg[2] = 0x3AA17AA1, stride = 0xD
OUT
Boot1: 2019-03-14, version: 1.19
CPUId = 0x0
mmc: ERROR: SDHCI ERR:cmd:0x102,stat:0x18000
mmc: ERROR: Card did not respond to voltage select!
emmc reinit
mmc: ERROR: SDHCI ERR:cmd:0x102,stat:0x18000
mmc: ERROR: Card did not respond to voltage select!
emmc reinit
mmc: ERROR: SDHCI ERR:cmd:0x102,stat:0x18000
mmc: ERROR: Card did not respond to voltage select!
SdmmcInit=2 1
UsbHook 57794
powerOn 57875
DDR Version 1.22 20190506
In
soft reset
DDR Version 1.22 20190506
In
Channel
1088
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
