mode: The mode parameter may be set to either "ro", "rw", "rwc", or "memory". Attempting to set it to any other value is an error. If "ro" is specified, then the database is opened for read-only access, just as if the SQLITE_OPEN_READONLY flag had been set in the third argument to sqlite3_open_v2(). If the mode option is set to "rw", then the database is opened for read-write (but not create) access, as if SQLITE_OPEN_READWRITE (but not SQLITE_OPEN_CREATE) had been set. Value "rwc" is equivalent to setting both SQLITE_OPEN_READWRITE and SQLITE_OPEN_CREATE. If the mode option is set to "memory" then a pure in-memory database that never reads or writes from disk is used. It is an error to specify a value for the mode parameter that is less restrictive than that specified by the flags passed in the third parameter to sqlite3_open_v2().
The sqlite3_open_v2() interface works like sqlite3_open() except that it accepts two additional parameters for additional control over the new database connection. The flags parameter to sqlite3_open_v2() can take one of the following three values, optionally combined with the SQLITE_OPEN_NOMUTEX, SQLITE_OPEN_FULLMUTEX, SQLITE_OPEN_SHAREDCACHE, SQLITE_OPEN_PRIVATECACHE, and/or SQLITE_OPEN_URI flags:
SQLITE_OPEN_READONLY
The database is opened in read-only mode. If the database does not already exist, an error is returned.
SQLITE_OPEN_READWRITE
The database is opened for reading and writing if possible, or reading only if the file is write protected by the operating system. In either case the database must already exist, otherwise an error is returned.
SQLITE_OPEN_READWRITE | SQLITE_OPEN_CREATE
The database is opened for reading and writing, and is created if it does not already exist. This is the behavior that is always used for sqlite3_open() and sqlite3_open16().
扫一扫
1314
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
