linux 7系统参数优化,centos7优化内核参数详解

下面内核优化是根据兰芷的BLOG上的内核优化基础上进行了添加,有兴趣的朋友可以拿去试试,具体好不好就看机器的表现了.

cat /etc/sysctl.conf

#CTCDN系统优化参数

#关闭ipv6

net.ipv6.conf.all.disable_ipv6 = 1

net.ipv6.conf.default.disable_ipv6 = 1

#决定检查过期多久邻居条目

net.ipv4.neigh.default.gc_stale_time=120

#使用arp_announce / arp_ignore解决ARP映射问题

net.ipv4.conf.default.arp_announce = 2

net.ipv4.conf.all.arp_announce=2

net.ipv4.conf.lo.arp_announce=2

# 避免放大攻击

net.ipv4.icmp_echo_ignore_broadcasts = 1

# 开启恶意icmp错误消息保护

net.ipv4.icmp_ignore_bogus_error_responses = 1

#关闭路由转发

net.ipv4.ip_forward = 0

net.ipv4.conf.all.send_redirects = 0

net.ipv4.conf.default.send_redirects = 0

#开启反向路径过滤

net.ipv4.conf.all.rp_filter = 1

net.ipv4.conf.default.rp_filter = 1

#处理无源路由的包

net.ipv4.conf.all.accept_source_route = 0

net.ipv4.conf.default.accept_source_route = 0

#关闭sysrq功能

kernel.sysrq = 0

#core文件名中添加pid作为扩展名

kernel.core_uses_pid = 1

# 开启SYN洪水攻击保护

net.ipv4.tcp_syncookies = 1

#修改消息队列长度

kernel.msgmnb = 65536

kernel.msgmax = 65536

#设置最大内存共享段大小bytes

kernel.shmmax = 68719476736

kernel.shmall = 4294967296

#timewait的数量，默认180000

net.ipv4.tcp_max_tw_buckets = 6000

net.ipv4.tcp_sack = 1

net.ipv4.tcp_window_scaling = 1

net.ipv4.tcp_rmem = 4096        87380   4194304

net.ipv4.tcp_wmem = 4096        16384   4194304

net.core.wmem_default = 8388608

net.core.rmem_default = 8388608

net.core.rmem_max = 16777216

net.core.wmem_max = 16777216

#每个网络接口接收数据包的速率比内核处理这些包的速率快时，允许送到队列的数据包的最大数目

net.core.netdev_max_backlog = 262144

#限制仅仅是为了防止简单的DoS 攻击

net.ipv4.tcp_max_orphans = 3276800

#未收到客户端确认信息的连接请求的最大值

net.ipv4.tcp_max_syn_backlog = 262144

net.ipv4.tcp_timestamps = 0

#内核放弃建立连接之前发送SYNACK 包的数量

net.ipv4.tcp_synack_retries = 1

#内核放弃建立连接之前发送SYN 包的数量

net.ipv4.tcp_syn_retries = 1

#启用timewait 快速回收

net.ipv4.tcp_tw_recycle = 1

#开启重用。允许将TIME-WAIT sockets 重新用于新的TCP 连接

net.ipv4.tcp_tw_reuse = 1

net.ipv4.tcp_mem = 94500000 915000000 927000000

net.ipv4.tcp_fin_timeout = 1

#当keepalive 起用的时候，TCP 发送keepalive 消息的频度。缺省是2 小时

net.ipv4.tcp_keepalive_time = 1800

net.ipv4.tcp_keepalive_probes = 3

net.ipv4.tcp_keepalive_intvl = 15

#允许系统打开的端口范围

net.ipv4.ip_local_port_range = 1024    65000

#修改防火墙表大小，默认65536

net.netfilter.nf_conntrack_max=655350

net.netfilter.nf_conntrack_tcp_timeout_established=1200

# 确保无人能修改路由表

net.ipv4.conf.all.accept_redirects = 0

net.ipv4.conf.default.accept_redirects = 0

net.ipv4.conf.all.secure_redirects = 0

net.ipv4.conf.default.secure_redirects = 0

vm.swappiness = 10

kernel.panic = 5

fs.file-max = 165535

# for high-latency network

net.ipv4.tcp_congestion_control = hybla

#maximize the available memory

vm.overcommit_memory = 1

vm.dirty_ratio = 1

vm.swappiness = 10

vm.vfs_cache_pressure = 110

#vm.zone_reclaim_mode = 0

#keep the IO performance steady

vm.dirty_background_ratio = 1

vm.dirty_writeback_centisecs = 100

vm.dirty_expire_centisecs = 100

夜空- 本站版权

1、本站所有主题由该文章作者发表，该文章作者与夜空享有文章相关版权

2、其他单位或个人使用、转载或引用本文时必须同时征得该文章作者和夜空的同意

3、本帖部分内容转载自其它媒体，但并不代表本站赞同其观点和对其真实性负责

4、如本帖侵犯到任何版权问题，请立即告知本站，本站将及时予与删除并致以最深的歉意

5、原文链接：blog.slogra.com/post-672.html