raid 物理盘缓存状态_Dell PowerEdge系列服务器RAID和物理磁盘开机自检错误信息及说明...

一、There are X enclosures connected to connector Y, but only maximum of 4 enclosures can be connected to a single SAS connector.Please remove the extra enclosures then restart your system.

当BIOS检测到单个SAS连接器连接的机柜超过4个时,会显示此消息。必须删除所有多余的机柜并重新启动系统。

二、Cache data was lost, but the controller has recovered.This could be due to the fact that your controller had protected cache after an unexpected power loss and your system was without power longer than the battery backup time.Press any key to continue, or ’C’ to load the configuration utility.

此消息在以下情况下出现:

•适配器检测到控制器高速缓存中的缓存数据尚未写入到磁盘子系统。

•控制器在初始化期间执行其高速缓存检查例行程序的同时,还检测到错误纠正代码(ECC)错误。

•由于无法保证数据完整性,所以控制器随即放弃高速缓存,而不是将其发送到磁盘子系统。要解决此问题,请将电池充满电。如果问题仍然存在,则电池或适配器 DIMM 可能出现故障。

三、The following virtual disks have missing disks: (x).If you proceed (or load the configuration utility), these virtual disks will be marked OFFLINE and will be inaccessible.Please check your cables and ensure all disks are present.Press any key to continue, or ’C’ to load the configuration utility.

该消息表示已删除某些配置的磁盘。如果没有卸除磁盘,则这些磁盘不再可访问。系统的 SAS 电缆可能连接不正确。请检查电缆连接并修复任何问题。重新启动系统。如果电缆没有问题,请按任意键继续。

四、All of the disks from your previous configuration are gone.If this is an unexpected message, then please power off your system and check your cables to ensure all disks are present.Press any key to continue, or ’C’ to load the configuration utility.

该消息表示所有配置的磁盘均已删除。如果没有卸除磁盘,则这些磁盘不再可访问。系统的 S

  • 3
    点赞
  • 3
    收藏
    觉得还不错? 一键收藏
  • 0
    评论

“相关推荐”对你有帮助么?

  • 非常没帮助
  • 没帮助
  • 一般
  • 有帮助
  • 非常有帮助
提交
评论
添加红包

请填写红包祝福语或标题

红包个数最小为10个

红包金额最低5元

当前余额3.43前往充值 >
需支付:10.00
成就一亿技术人!
领取后你会自动成为博主和红包主的粉丝 规则
hope_wisdom
发出的红包
实付
使用余额支付
点击重新获取
扫码支付
钱包余额 0

抵扣说明:

1.余额是钱包充值的虚拟货币,按照1:1的比例进行支付金额的抵扣。
2.余额无法直接购买下载,可以购买VIP、付费专栏及课程。

余额充值