思科、华为、华三交换机配置端口聚合

最新推荐文章于 2024-06-03 23:13:28 发布

请叫我常总裁

最新推荐文章于 2024-06-03 23:13:28 发布

阅读量3.1k

点赞数

分类专栏：网络交换机文章标签：端口聚合链路聚合

本文链接：https://blog.csdn.net/weixin_43055250/article/details/127672206

版权

网络交换机专栏收录该内容

6 篇文章 0 订阅

订阅专栏

华为-配置LACP模式的链路聚合

[HUAWEI] interface eth-trunk 1

[HUAWEI-Eth-Trunk1] mode lacp

[HUAWEI-Eth-Trunk1] trunkport gigabitethernet 1/0/1 to 1/0/3

[HUAWEI-Eth-Trunk1] port link-type trunk

[HUAWEI-Eth-Trunk1] port trunk allow-pass vlan 10 20

[HUAWEI-Eth-Trunk1] quit

华三-二层静态聚合配置举例

1、# 创建二层聚合接口1

[H3C] interface bridge-aggregation 1

[H3C-Bridge-Aggregation1] quit

2、# 分别将端口GigabitEthernet1/0/1至GigabitEthernet1/0/3加入到聚合组1中。

[H3C] interface gigabitethernet 1/0/1

[H3C-GigabitEthernet1/0/1] port link-aggregation group 1

[H3C-GigabitEthernet1/0/1] quit

[H3C] interface gigabitethernet 1/0/2

[H3C-GigabitEthernet1/0/2] port link-aggregation group 1

[H3C-GigabitEthernet1/0/2] quit

[H3C] interface gigabitethernet 1/0/3

[H3C-GigabitEthernet1/0/3] port link-aggregation group 1

[H3C-GigabitEthernet1/0/3] quit

3、# 配置二层聚合接口1为Trunk端口，并允许VLAN 100的报文通过。

[H3C] interface bridge-aggregation 1

[H3C-Bridge-Aggregation1] port link-type trunk

[H3C-Bridge-Aggregation1] port trunk permit vlan 100

[H3C-Bridge-Aggregation1] quit

思科配置链路聚合

进入全局模式：Switch#conf t
进入交换机接口：Sw1(config)#int range f0/1-2
更改接口传输模式：Sw1(config-if)#switchport mode trunk
将接口绑定链路聚合1：Sw1(config-if-range)#channel-group 1 mode on
允许所有vlan通过：Sw1(config-if)#switchport trunk allowed vlan all