STC频率和占空比（可调）

/******注意 单片机必须是52rc不能用60s2/

unsigned int uiHighTH0 = 0; //高电平重载值的高字节
unsigned int uiHighTL0 = 0; //高电平重载值的低字节
unsigned int uiLowTH0 = 0; //低电平重载值的高字节
unsigned int uiLowTL0 = 0; //低电平重载值的低字节

bit bStartAndClosePwmOutFlag = 0; //开始和启动PWM输出

/* 配置并启动PWM，fr-频率，dc-占空比 */
void Set_Freq_And_Duty_Out_Fun(unsigned int uiFreq, unsigned char ucDuty)
{
unsigned int uiHigh, uiLow;
unsigned long ulCountValue;

ulCountValue  = (FOSC/12)/uiFreq;  //计算一个周期所需的计数值
uiHigh = (ulCountValue*ucDuty) / 100;      //计算高电平所需的计数值
uiLow  = ulCountValue - uiHigh;          //计算低电平所需的计数值
uiHigh = 65536 - uiHigh + 2;   //计算高电平的重载值并补偿中断延时
uiLow  = 65536 - uiLow  + 2;   //计算低电平的重载值并补偿中断延时	
uiHighTH0 = (unsigned char)(uiHigh>>8); //高电平重载值拆分为高低字节
uiHighTL0 = (unsigned char)uiHigh;
uiLowTH0  = (unsigned char)(uiLow>>8);  //低电平重载值拆分为高低字节
uiLowTL0  = (unsigned char)uiLow;

AUXR &= 0x7f; 		//定时器时钟12T模式
TMOD &= 0xF0;       //清零T0的控制位
TMOD |= 0x01;       //配置T0为模式1
TH0 = uiHighTH0;    //加载T0重载值
TL0 = uiHighTL0;
ET0 = 1;        	//开定时器T1中断允许
TR0 = 1;        	//关闭定时器0
bStartAndClosePwmOutFlag = 0;    	    //输出高电平

}

/* T0中断服务函数，产生PWM输出 */
void InterruptTimer0() interrupt 1
{
if (bStartAndClosePwmOutFlag == 0) //当前输出为高电平时，装载低电平值并输出低电平
{
bStartAndClosePwmOutFlag = 1;
TH0 = uiLowTH0;
TL0 = uiLowTL0;
PWM = 0;
}
else //当前输出为低电平时，装载高电平值并输出高电平
{
bStartAndClosePwmOutFlag = 0;
TH0 = uiHighTH0;
TL0 = uiHighTL0;
PWM = 1;
}
}
/*****************************************************************************************************/

链接->http://www.51hei.com/bbs/dpj-172705-1.html