- 在路由器接口上用命令ip multicast ttl-threshold ttl-value设定TTL阀值:dallasr1>(config-if)# ip multicast ttl-threshold ttl-value
- 用show ip pim neighbor显示PIM邻居表。
- 显示组播通信路由表中的各条记录: dallasr1>show ip mroute [group-name|group-address][scoure][summary][count][active kbps]
- 要记录一个路由器接受和发送的全部IP组播包:dallasr1> #debug ip mpacket [detail] [access-list][group]
- 要在CISCO路由器上配置CGMP: dallasr1>(config-if)# ip cgmp
75.配置一个组播路由器,使之加入某一个特定的组播组: dallasr1>(config-if)# ip igmp join-group group-address - 关闭 CGMP: dallasr1>(config-if)# no ip cgmp
- 启动交换机上的CGMP: dallasr1>(enable) set cgmp enable
- 核实Catalyst交换机上CGMP的配置情况: catalystla1>(enable) show config
set prompt catalystla1>
set inte***ce sc0 192.168.1.1 255.255.255.0
set cgmp enable - CGMP离开的设置: Dallas_SW(enable) set cgmp leave
思科命令大全 八
最新推荐文章于 2024-07-13 08:52:42 发布