先看仪表log,可以看到log中只有0.00346666666667Mbps,说明了速率很低
~~~~~ Storing throughput ~~~~~
Mon, 11 Sep 2023 13:13:06 INFO strmTimeStampList2 count 1
Mon, 11 Sep 2023 13:13:06 INFO Storing $X1 = 0.00346666666667 [Mbps]
Mon, 11 Sep 2023 13:13:06 INFO strmTimeStampList2 count 1
Mon, 11 Sep 2023 13:13:06 INFO Storing $X2 = 0.00626666666667 [Mbps]
Mon, 11 Sep 2023 13:13:06 INFO strmTimeStampList2 count 1
Mon, 11 Sep 2023 13:13:06 INFO Storing $X3 = 0.00546666666667 [Mbps]
Mon, 11 Sep 2023 13:13:06 INFO
~~~~~ Prereq-DUT-->AP - Total throughput (Mbps) ~~~~~
Mon, 11 Sep 2023 13:13:06 INFO $X1=0.0152
Mon, 11 Sep 2023 13:13:06 INFO
TEST RESULT ---> FAIL | Pre-requisite throughput lower than expected |
再看文档中怎么定义的,(UDP Total Tput 必须 > 150 Mbps,如果没有,请在继续之前检查是否存在环境干扰。)