HCIP IPv6实验

 要求：全网可达

首先分析在图中r1、r2为双栈，r1、r2、r9、r10跑IPv4；r1、r2、r9、r10、r11跑IPv6

r1的配置为

[r1]int g0/0/0
[r1-GigabitEthernet0/0/0]ip address 12.1.1.1 24

[r1]int lo0
[r1-LoopBack0]ip address 1.1.1.1 32

[r1]ip route-static 0.0.0.0 0 12.1.1.2

r2的配置为

[r2]int g0/0/0
[r2-GigabitEthernet0/0/0]ip address 12.1.1.2 24

[r2]int lo0
[r2-LoopBack0]ip address 2.2.2.2 32

[r2]int g0/0/1
[r2-GigabitEthernet0/0/1]ip address 29.1.1.1 24

[r2]ip route-static 0.0.0.0 0 29.1.1.2

[r2]acl 2000
[r2-acl-basic-2000]rule permit source any 
[r2]int g0/0/1
[r2-GigabitEthernet0/0/1]nat outbound 2000

用r1去ping r9的环回

r10的配置为

[r10]int g0/0/0
[r10-GigabitEthernet0/0/0]ip address 91.1.1.2 24

[r10]int l0
[r10-LoopBack0]ip address 10.10.10.10 32

[r10]ip route-static 0.0.0.0 0 91.1.1.1

r9的配置为

[r9]int g0/0/0
[r9-GigabitEthernet0/0/0]ip address 29.1.1.2 24

[r9]int l0
[r9-LoopBack0]ip address 9.9.9.9 32

[r9]int g0/0/1
[r9-GigabitEthernet0/0/1]ip address 91.1.1.1 24

在r10上ping r9的环回

 IPv4配置完成，现在开始配置IPv6

跨运营商要建立6to4tunnel，建立6to4 tunnel之前先将ipv4地址化为ipv6地址

将29.1.1.1化为ipv6地址为2002：1D01：0101：： 64

r1的配置为

[r1]ipv6
[r1]int g0/0/0
[r1-GigabitEthernet0/0/0]ipv6 enable 	
[r1-GigabitEthernet0/0/0]ipv6 address 2002:1D01:0101::1 64

[