基于标准外设库的LED流水灯
创建工程
用标准外设库方式使用某个端口GPIOx端口管脚控制几个LED灯,轮流闪烁,间隔时长1秒
主函数代码
#include “stm32f10x.h” // Device header
#include “Delay.h”
int main(void)
{
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);
GPIO_InitTypeDef GPIO_InitStructure;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP;
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_All;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_Init(GPIOA, &GPIO_InitStructure);
while (1)
{
GPIO_Write(GPIOA, ~0x0001); //0000 0000 0000 0001
Delay_ms(1000);
GPIO_Write(GPIOA, ~0x0002); //0000 0000 0000 0010
Delay_ms(1000);
GPIO_Write(GPIOA, ~0x0004); //0000 0000 0000 0100
Delay_ms(1000);
GPIO_Write(GPIOA, ~0x0008); //0000 0000 0000 1000
Delay_ms(1000);
GPIO_Write(GPIOA, ~0x0010); //0000 0000 0001 0000
Delay_ms(1000);
GPIO_Write(GPIOA, ~0x0020); //0000 0000 0010 0000
Delay_ms(1000);
GPIO_Write(GPIOA, ~0x0040); //0000 0000 0100 0000
Delay_ms(1000);
GPIO_Write(GPIOA, ~0x0080); //0000 0000 1000 0000
Delay_ms(1000);
//GPIO_Write(GPIOA, ~0x0010); //0000 0000 0000 1000
//Delay_ms(2000);
}
}
编译结果
烧录进单片机
A0-A7管脚的LED依次闪烁,间隔1S
使用Keil的软件仿真逻辑分析仪功能观察管脚的时序波形
仿真结果如下