H3C的IRF配置

堆叠配置方式1（快速）

IRF快速配置的方式
此处安装两台设备堆叠，堆叠口为53和54口，MAD配置为48口作为案例

1、master的配置
[SW1]easy-irf member 1 domain 10 irf-port2 FortyGigE 1/0/53 FortyGigE 1/0/54
2、slave的配置
[SW2]irf member 1 remember 2
<SW2>sa fo
<SW2>reboot
[SW2]easy-irf member 2 domain 10 irf-port1 FortyGigE 2/0/53 FortyGigE 2/0/54
3、配置bfd mad
[SW1]interface Route-Aggregation 1024
[SW1]int range GigabitEthernet 1/0/48 GigabitEthernet 2/0/48
[SW1-if-range]p l r
[SW1-if-range]port link-aggregation group 1024

[SW1]interface Route-Aggregation 1024
[SW1-Route-Aggregation1024]mad bfd enable
[SW1-Route-Aggregation1024]mad ip address 1.1.1.1 30 member 1
[SW1-Route-Aggregation1024]mad ip address 1.1.1.2 30 member 2

标题堆叠配置方式2（传统）

传统的irf配置步骤：
1. 将slave的member号改为非1，保存配置，重启
2. 配置master的优先级
3. 配置master的irf口，先关闭相关接口，配置完成后再打开端口，保存配置
4. 配置slave的优先级，配置slave的irf口，先关闭相关接口，配置完成后再打开，保存配置
5. 激活irf，等待slave重启
6. 配置bfd mad
7. 验证

此处配置省略，配置的最终效果和快速配置一致，

其他mad配置方法2

vlan 4090
description MAD

interface GigabitEthernet1/0/48
port access vlan 4090
undo stp enable

interface GigabitEthernet2/0/48
port access vlan 4090
undo stp enable

interface Vlan-interface4090
mad bfd enable
mad ip address 1.1.1.1 255.255.255.252 member 1
mad ip address 1.1.1.2 255.255.255.252 member 2

验证

[SW1]display mad verbose //查看MAD的状态
[SW1]display irf link //显示IRF链路信息
[SW1]display irf configuration //显示IRF配置信息