交换机telnet配置

交换机SW2 :

[SW2]vlan batch 10  //创建vlan 10
[SW2]interface g0/0/1
[SW2-GigabitEthernet0/0/1]port link-type access  //设置端口类型为access
[SW2-GigabitEthernet0/0/1]port default vlan 10   //将端口g0/0/1加入vlan 10
[SW2-GigabitEthernet0/0/1]quit
[SW2]
[SW2]telnet server enable  //开启远程登录服务

[SW2]user-interface vty 0 4    //进入vty控制台;0  4 代表最多可以同时登录5个用户
[SW2-ui-vty0-4]protocol inbound telnet     //配置允许登录接入用户类型的协议为telnet
[SW2-ui-vty0-4]authentication-mode aaa   //设置认证方式为aaa认证 

[SW2]aaa    //进入AAA视图
[SW2-aaa]local-user test password cipher 123   //添加新用户并设置密码
[SW2-aaa]local-user test privilege level 15    //设置用户的等级，最高为15
[SW2-aaa]quit
[SW2]
[SW2]interface vlanif 10
[SW2-Vlanif10]ip address 192.168.1.2 24

 交换机SW1：

[SW1]vlan batch 10
[SW1]interface g0/0/1
[SW1-GigabitEthernet0/0/1]port link-type access  //设置端口类型为access
[SW1-GigabitEthernet0/0/1]port default vlan 10   //将g0/0/1加vlan 10
[SW1-GigabitEthernet0/0/1]quit
[SW1]interface vlanif 10
[SW1-Vlanif10]ip address 192.168.1.1 24
[SW1-Vlanif10]q

测试：

<SW1>telnet 192.168.1.2

远程登陆成功的画面: