【WCN685X】WCN6856 5G吞吐量测试只有25Mbps问题原因分析及解决方案

wellnw

已于 2022-09-18 10:18:03 修改

阅读量799

点赞数

分类专栏： WiFi Driver 文章标签： WiFi X62

于 2022-09-13 22:58:09 首次发布

本文链接：https://blog.csdn.net/wgl307293845/article/details/126843321

版权

WiFi Driver 专栏收录该内容

112 篇文章 33 订阅 ¥129.90 ¥299.90

订阅专栏

超级会员免费看

博客分析了WCN6856 5G网络吞吐量仅为25Mbps的问题，发现由于配置错误导致设备工作在802.11a 20MHz模式。解决方案是修改hostapd.conf配置，启用802.11ax 80MHz模式，测试后吞吐量提升至680Mbps。

摘要由CSDN通过智能技术生成

hostapd默认配置参数

##### hostapd configuration file ##############################################
# Empty lines and lines starting with # are ignored

# AP netdevice name (without 'ap' postfix, i.e., wlan0 uses wlan0ap for
# management frames); ath0 for madwifi
interface=wlan0

# In case of madwifi, atheros, and nl80211 driver interfaces, an additional
# configuration parameter, bridge, may be used to notify hostapd if the
# interface is included in a bridge. This parameter is not used with Host AP
# driver. If the bridge parameter is not set, the drivers will automatically
# figure out the bridge interface (assuming sysfs is enabled and mounted to
# /sys) and this parameter may not be needed.
#
# For nl80211, this parameter can be used to request