【WCN685X】WCN6856 WiFi 6E出现无法扫描到信号问题分析及解决方案

问题描述

      WiFi 6E启动之后使用终端无法扫描到Ap的SSID

后台看AP状态也是正常如下

 # iw wlan2 info
Interface wlan2
        ifindex 25
        wdev 0x100000003
        addr 11:22:33:44:55:c5
        ssid test-6GHz
        type AP
        wiphy 1
        channel 227 (6135 MHz), width: 80 MHz, center1: 6145 MHz
        txpower 17.00 dBm

 hostapd查看状态也是正常

 # hostapd_cli -i wlan2 status
state=ENABLED
phy=phy1
freq=6135
num_sta_non_erp=0
num_sta_no_short_slot_time=0
num_sta_no_short_preamble=0
olbc=0
num_sta_ht_no_gf=0
num_sta_no_ht=0
num_sta_ht_20_mhz=0
num_sta_ht40_intolerant=0
olbc_ht=0
ht_op_mode=0x0
cac_time_seconds=0
cac_time_left_seconds=N/A
channel=37
edmg_en