Zookeeper 搭建
前置环境:Centos7+hadoop-2.8.4
- tar -zxvf zookeeper-3.4.10.tar.gz -C /opt/module #文件解压目录可根据需求更改
- 重命名并且更改配置文件
cd zookeeper-3.4.10.tar.gz/conf
mv zoo_sample.cfg zoo.cfg
vi zoo.cfg
# The number of milliseconds of each tick
tickTime=2000
# The number of ticks that the initial
# synchronization phase can take
initLimit=10
# The number of ticks that can pass between
# sending a request and getting an acknowledgement
syncLimit=5
# the directory where the snapshot is stored.
# do not use /tmp for storage, /tmp here is just
# example sakes.
dataDir=/opt/module/zookeeper-3.4.10/data
dataLogDir=/opt/module/zookeeper-3.4.10/dataLog
# the port at which the clients will connect
clientPort=2181
# the maximum number of client connections.
# increase this if you need to handle more clients
#maxClientCnxns=60
#
# Be sure to read the maintenance section of the
# administrator guide before turning on autopurge.
#
# http://zookeeper.apache.org/doc/current/zookeeperAdmin.html#sc_maintenance
#
# The number of snapshots to retain in dataDir
#autopurge.snapRetainCount=3
# Purge task interval in hours
# Set to "0" to disable auto purge feature
#autopurge.purgeInterval=1
这是我的zoo.cfg文件,由于是单节点所以最后不配节点没有关系,如果配置集群的话一定要加
3. 创建data与dataLog
cd zookeeper-3.4.10
mkdir data
mkdir dataLog
4. 启动zookeeper
bin/zkServer.sh start
5. 查看
bin/zkServer.sh status
或者
打开浏览器输入192.168.52.50:8088