U-Boot 1.1.6 (Build time: Oct 5 2009 - 06:30:20)
SRX_210_VOICE board revision major:0, minor:0, serial #: AAAXXXXX
OCTEON CN5020-SCP pass 1.1, Core clock: 400 MHz, DDR clock: 200 MHz (400 Mhz data rate)
DRAM: 1024 MB
Starting Memory POST...
Checking datalines... OK
Checking address lines... OK
Checking 512K memory for U-Boot... OK.
Running U-Boot CRC Test... OK.
Flash: 4 MB
USB: scanning bus for devices... 3 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
Clearing DRAM........ done
BIST check passed.
Starting PCI
PCI Status: PCI 32-bit
PCI BAR 0: 0xf8000000, PCI BAR 1: Memory 0x00000000 PCI 0x00000000
Net: octeth0
POST Passed
Press SPACE to abort autoboot in 1 seconds
ELF file is 32 bit
Loading .text @ 0x8f000078 (241008 bytes)
Loading .rodata @ 0x8f03ade8 (13908 bytes)
Loading .rodata.str1.4 @ 0x8f03e43c (15972 bytes)
Loading set_Xcommand_set @ 0x8f0422a0 (96 bytes)
Loading .rodata.cst4 @ 0x8f042300 (20 bytes)
Loading .data @ 0x8f043000 (5572 bytes)
Loading .data.rel.ro @ 0x8f0445c4 (120 bytes)
Loading .data.rel @ 0x8f04463c (136 bytes)
Clearing .bss @ 0x8f0446c8 (8304 bytes)
## Starting application at 0x8f000078 ...
Consoles: U-Boot console
Found compatible API, ver. 1.5
FreeBSD/MIPS U-Boot bootstrap loader, Revision 1.5 (看到这行,开始连按空格键)
(builder@ormonth.juniper.net, Mon Oct 5 05:46:18 UTC 2009)
Memory: 1024MB
[2]Booting from nand-flash slice 1
Un-Protected 1 sectors
writing to flash...
Protected 1 sectors
Loading /boot/defaults/loader.conf
/kernel data=0xa1dac0+0xdbfe4 syms=[0x4+0x7fb30+0x4+0xb7345]
Hit [Enter] to boot immediately, or space bar for command prompt.
Type '?' for a list of commands, 'help' for more detailed help.
loader> (进入loader)
loader> set ipaddr=192.168.1.112
loader> set serverip=192.168.1.111
loader> set netmask=255.255.255.0
loader> set gatewayip=192.168.1.254
loader> save
Saving environment to flash... Un-Protected 1 sectors
Erasing Flash...
. done
Erased 1 sectors
Writing to Flash... writing to flash...
done
Protected 1 sectors
done
loader> install --format tftp://192.168.1.111/junos-srxsme-12.1X46-D72.2-domestic.tgz
octeth0: Up 1000 Mbps Full duplex (port 0) (使用机器的0/0口)
/kernel data=0xb170f4+0x134b14 syms=[0x4+0x8bc70+0x4+0xcaeeb]
Kernel entry at 0x801000e0 ...
init regular console
Primary ICache: Sets 64 Size 128 Asso 4
Primary DCache: Sets 1 Size 128 Asso 64
Secondary DCache: Sets 128 Size 128 Asso 8
GDB: debug ports: uart
GDB: current port: uart
KDB: debugger backends: ddb gdb
KDB: current backend: ddb
kld_map_v: 0x8ff80000, kld_map_p: 0x0
Copyright (c) 1996-2017, Juniper Networks, Inc.
All rights reserved.
Copyright (c) 1992-2006 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
JUNOS 12.1X46-D72.2 #0: 2017-12-23 09:11:03 UTC
builder@tenneth-vm01.juniper.net:/volume/build/junos/12.1/service/12.1X46-D72.2/obj-octeon/junos/bsd/kernels/JSRXNLE/kernel
JUNOS 12.1X46-D72.2 #0: 2017-12-23 09:11:03 UTC
builder@tenneth-vm01.juniper.net:/volume/build/junos/12.1/service/12.1X46-D72.2/obj-octeon/junos/bsd/kernels/JSRXNLE/kernel
real memory = 1073741824 (1024MB)
avail memory = 559992832 (534MB)
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
Security policy loaded: JUNOS MAC/pcap (mac_pcap)
Security policy loaded: JUNOS MAC/runasnonroot (mac_runasnonroot)
netisr_init: !debug_mpsafenet, forcing maxthreads from 2 to 1
cpu0 on motherboard
: CAVIUM's OCTEON 5020 CPU Rev. 0.1 with no FPU implemented
L1 Cache: I size 32kb(128 line), D size 8kb(128 line), sixty four way.
L2 Cache: Size 128kb, 8 way
obio0 on motherboard
uart0: <Octeon-16550 channel 0> on obio0
uart0: console (9600,n,8,1)
twsi0 on obio0
dwc0: <Synopsis DWC OTG Controller Driver> on obio0
usb0: <USB Bus for DWC OTG Controller> on dwc0
usb0: USB revision 2.0
uhub0: vendor 0x0000 DWC OTG root hub, class 9/0, rev 2.00/1.00, addr 1
uh