gentoo linux 无线网络配置

首先安装无线网卡驱动及fireware固件    http://blog.csdn.net/wps712/article/details/17978319

内核配置

我的网卡是：Network controller: Intel Corporation Centrino Ultimate-N 6300

配置无线网络协议栈

[*] Networking support  --->
    [*] Wireless  --->
        <*> cfg80211 - wireless configuration API
        <*> Generic IEEE 802.11 Networking Stack (mac80211)

        Optionally enable a Wifi LED:
        [*] Enable LED triggers




配置网卡驱动       


[*] Networking support   --->
         --- Wireless   --->                                                                                    

                          <M>   cfg80211 - wireless configuration API                                                     

                                 [ ]     nl80211 testmode command                                                                  

                                 [ ]     enable developer warnings                                                                 

                                 [ ]     cfg80211 regulatory debugging                                                             

                                 [ ]     enable powersave by default                                                               

                                 [ ]     cfg80211 DebugFS entries                                                                  

                                 [*]     cfg80211 wireless extensions compatibility                                         

                          [ ]   lib80211 debugging messages                                                                 

                          <M>   Generic IEEE 802.11 Networking Stack (mac80211)                      

                                 Default rate control algorithm (Minstrel)  --->                                         

                          [ ]   Enable mac80211 mesh networking (pre-802.11s) support          

                          -*-   Enable LED triggers                     

安装固件
    emerge --ask sys-firmware/iwl60000-ucode
编译内核重启，配置网络

启用网卡


      # ifconfig wlan0 up
安装工具iwconfig   


      # emerge net-wireless/wireless-tools
扫描网络
      # iwlist wlan0 scan      找到ESSID
      # iwlist wlan0 scan | grep ESSID
安装wpa


      # emerge net-wireless/wpa_supplicant
生成配置文件
      # wpa_passphrase <ssid> <password>     >     wpa.conf
启用网络
      # wpa_supplicant -i wlan0 -B -c wpa.conf
获得ip
      # dhcpcd wlan0