IPv6静态路由设置

 

 路由器 Router2 的配置：

Router>enable

Router#conf ter

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)#ipv6 unicast-routing     （开启 IPv6 单播路由）

Router(config)#inter fa0/0

Router(config-if)#ipv6 address 2005:cccc::1/64    （设置 fa/0 口的 IPv6 地址）

Router(config-if)#no shutdown

%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up

Router(config-if)#exit

Router(config)#interface Serial0/1/0

Router(config-if)#ipv6 address 2007:cccc::1/64

Router(config-if)#clock rate 128000

Router(config-if)#exit

Router(config)#ipv6 route 2004:cccc::/64 Serial0/1/0 （ 设置IPv6静态路由 ）

路由器 Router3 的配置：

Router>enable

Router#conf ter

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)#ipv6 unicast-routing     （开启 IPv6 单播路由）

Router(config)#inter fa0/0

Router(config-if)#ipv6 address 200 4 :cccc::1/64    （设置 fa/0 口的 IPv6 地址）

Router(config-if)#no shutdown



%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up

Router(config-if)#exit

Router(config)#interface Serial0/1/0

Router(config-if)#ipv6 address 2007:cccc:: 2 /64

Router(config-if)#clock rate 128000

Router(config-if)#exit

Router(config)#ipv6 route 200 5 :cccc::/64 Serial0/1/0 （ 设置IPv6静态路由 ）

配置完成后，在 PC 里配置 IPV6

 设置默认网关

 在 PC 0 上通过 ping 命令测试与 pc1 的连通性，结果如下

PC>ping 2004:CCCC::2



Pinging 2004:CCCC::2 with 32 bytes of data:



Reply from 2004:CCCC::2: bytes=32 time=25ms TTL=126

Reply from 2004:CCCC::2: bytes=32 time=11ms TTL=126

Reply from 2004:CCCC::2: bytes=32 time=20ms TTL=126

Reply from 2004:CCCC::2: bytes=32 time=13ms TTL=126



Ping statistics for 2004:CCCC::2:

    Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milli-seconds:

    Minimum = 11ms, Maximum = 25ms, Average = 17ms

Ping 通了。。。实验完成。

让我们来看下 Router 2 里面的路由表

Router#show ipv6 route

IPv6 Routing Table - 6 entries

Codes: C - Connected, L - Local, S - Static, R - RIP, B - BGP

       U - Per-user Static route, M - MIPv6

       I1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea, IS - ISIS summary

       O - OSPF intra, OI - OSPF inter, OE1 - OSPF ext 1, OE2 - OSPF ext 2

       ON1 - OSPF NSSA ext 1, ON2 - OSPF NSSA ext 2

       D - EIGRP, EX - EIGRP external

S   2004:CCCC::/64 [1/0]

     via ::, Serial0/3/0

C   2005:CCCC::/64 [0/0]

     via ::, FastEthernet0/0

L   2005:CCCC::1/128 [0/0]

     via ::, FastEthernet0/0

C   2007:CCCC::/64 [0/0]

     via ::, Serial0/3/0

L   2007:CCCC::1/128 [0/0]

     via ::, Serial0/3/0

L   FF00::/8 [0/0]

     via ::, Null0