三层架构实验

拓扑图

要求全网通

首先基于vlan1进行sw5和sw6的地址的配置

[Huawei]interface Vlanif 1

[Huawei-Vlanif1]ip address 23.1.1.2 24

汇聚

用trunk

[Huawei]interface Eth-Trunk 1

[Huawei]interface GigabitEthernet 0/0/2

[Huawei-GigabitEthernet0/0/2]eth-trunk 1

[Huawei]interface Eth-Trunk 1

[Huawei-Eth-Trunk1]port link-type trunk 

[Huawei-Eth-Trunk1]port trunk allow-pass vlan all 

先在接口配置vlan

[Huawei]vlan batch 2 3

[Huawei-GigabitEthernet0/0/2]port link-type access 

[Huawei-GigabitEthernet0/0/2]port default vlan 2

[Huawei-GigabitEthernet0/0/4]port link-type trunk 

[Huawei-GigabitEthernet0/0/4]port trunk allow-pass vlan all 

[sw1]port-group 1

[sw1-port-group-1]group-member e0/0/1 to e0/0/4

生成树

[sw5]stp mode msdp

[sw5]stp region-configuration

[sw5-mst-region]instance 1 vlan 1 to 5

[sw5-mst-region]instance 2 vlan 6 to 10

[sw5-mst-region]active region-configuration

[sw5]stp instance 1 root primary

[sw5]stp instance 2 root secondary 

[sw5-Vlanif3]vrrp vrid 2 virtual-ip 172.16.1.2

DHCP下放

[sw5]dhcp enable 

[sw5]ip pool 1

[sw5-ip-pool-1]network 192.168.1.0 mask 24

[sw5-ip-pool-1]gateway-list 192.168.1.1

[sw5-ip-pool-1]dns-list 8.8.8.8

[sw5-Vlanif3]dhcp select global 

r1sw5sw6跑ospf

[r1]ospf 1 router-id 1.1.1.1

[r1-ospf-1-area-0.0.0.0]network 23.1.1.1 0.0.0.0

[r1-ospf-1-area-0.0.0.0]network 34.1.1.1 0.0.0.0

[r1-ospf-1-area-0.0.0.0]undo network 2.2.2.2 0.0.0.0

[r1-ospf-1]default-route-advertise

r1上跑nat

[r1]acl 2000

[r1-acl-basic-2000]rule permit source any 

[r1]interface GigabitEthernet 0/0/0

[r1-GigabitEthernet0/0/0]nat outbound 2000

全网通