chrony.conf 配置文件修改 —— 授时同步环境搭建2

//chrony.conf

# Welcome to the chrony configuration file. See chrony.conf(5) for more
# information about usuable directives.

# This will use (up to):
# - 4 sources from ntp.ubuntu.com which some are ipv6 enabled
# - 2 sources from 2.ubuntu.pool.ntp.org which is ipv6 enabled as well
# - 1 source from [01].ubuntu.pool.ntp.org each (ipv4 only atm)
# This means by default, up to 6 dual-stack and up to 2 additional IPv4-only
# sources will be used.
# At the same time it retains some protection against one of the entries being
# down (compare to just using one of the lines). See (LP: #1754358) for the
# discussion.
#
# About using servers from the NTP Pool Project in general see (LP: #104525).
# Approved by Ubuntu Technical Board on 2011-02-08.
# See http://www.pool.ntp.org/join.html for more information.
#pool ntp.ubuntu.com        iburst maxsources 4
#pool 0.ubuntu.pool.ntp.org iburst maxsources 1
#pool 1.ubuntu.pool.ntp.org iburst maxsources 1
#pool 2.ubuntu.pool.ntp.org iburst maxsources 2

# This directive specify the location of the file containing ID/key pairs for
# NTP authentication.
#refclock PPS /dev/pps0 lock GPSD prefer refid PPS
#refclock SHM 0 offset 0.0 delay 0.2 refid GPSD
refclock PPS /dev/pps0 lock NMEA refid GPS
refclock SHM 0 offset 0.5 delay 0.2 refid NMEA noselect
keyfile /etc/chrony/chrony.keys

# This directive specify the file into which chronyd will store the rate
# information.
driftfile /var/lib/chrony/chrony.drift

# Uncomment the following line to turn logging on.
#log tracking measurements statistics

# Log files location.
logdir /var/log/chrony

# Stop bad estimates upsetting machine clock.
maxupdateskew 100.0
leapsectz right/UTC
# This directive enables kernel synchronisation (every 11 minutes) of the
# real-time clock. Note that it can’t be used along with the 'rtcfile' directive.
rtcsync

# Step the system clock instead of slewing it if the adjustment is larger than
# one second, but only in the first three clock updates.
makestep 1.0 -1

# Allow NTP client access from local network.
allow 192.168.0.0/16
allow 10.10.0.0/16

 

// etc_rc.local 文件

"rc.local"
#!/bin/bash
sleep 30
echo "start ptpd ..."

if [ -f /opt/MVS/bin/set_rp_filter.sh ]; then
        bash /opt/MVS/bin/set_rp_filter.sh
fi

sudo mount /dev/nvme0n1p1 /home/nvidia/data &

/usr/sbin/ptpd -C -M -i eth4 &
/usr/local/mec/bin/tzupgrade.sh &