【lvs】添加dr模式负载

环境及要求

模式为dr模式添加负载，192.168.150.10及11分别为lvs主从机，负载情况如下

192.168.150.158:3600
       |_______192.168.150.100:3600
       |_______192.168.150.101:3600

配置

1.先修改lvs主机192.168.150.10的配置文件 /etc/sysconfig/ha/lvs.cf

#/etc/sysconfig/ha/lvs.cf
serial_no = 172
primary = 192.168.150.10
service = lvs
backup_active = 1
backup = 192.168.150.11
heartbeat = 1
heartbeat_port = 539
keepalive = 6
deadtime = 18
network = direct  #注意由于是dr所以network参数为direct
debug_level = NONE
monitor_links = 0
syncdaemon = 0
#中间省略以前的负载配置
。
。
。
#在最下面添加这段
virtual 3600 {
     active = 1
     address = 192.168.150.158 bond0:0
     vip_nmask = 255.255.255.0
     port = 3600
     use_regex = 0
     load_monitor = none
     scheduler = wlc
     protocol = tcp
     timeout = 6
     reentry = 15
     quiesce_server = 0
     server 3600 {
         address = 192.168.150.100
         active = 1
         port = 3600
         weight = 1
     }
     server 3600 {
         address = 192.168.150.101
         active = 1
         port = 3600
         weight = 1
     }
}

2.修改后将该文件传至备机，并修改属组

chown root:piranha lvs.cf

3.【必须】先重启192.168.150.11备机的pulse

#备机192.168.150.11
service pulse restart 

4.再重启192.168.150.10主机pulse

#主机192.168.150.10
service pulse restart 

5.重启后如果realserver上还未启动监听端口，那么在lvs主机上用命令ipvsadm -ln只能看到virtual server，无法看到realserver情况，这点要注意。