三、hystrix dashboard界面监控参数
四、配置信息(default或HystrixCommandKey)最常用的几项
超时时间(默认1000ms,单位:ms)
(1)hystrix.command.default.execution.isolation.thread.timeoutInMilliseconds
在调用方配置,被该调用方的所有方法的超时时间都是该值,优先级低于下边的指定配置
(2)hystrix.command.HystrixCommandKey.execution.isolation.thread.timeoutInMilliseconds
在调用方配置,被该调用方的指定方法(HystrixCommandKey方法名)的超时时间是该值
线程池核心线程数
hystrix.threadpool.default.coreSize(默认为10)
Queue
(1)hystrix.threadpool.default.maxQueueSize(最大排队长度。默认-1,使用SynchronousQueue。其他值则使用 LinkedBlockingQueue。如果要从-1换成其他值则需重启,即该值不能动态调整,若要动态调整,需要使用到下边这个配置)
(2)hystrix.threadpool.default.queueSizeRejectionThreshold(排队线程数量阈值,默认为5,达到时拒绝,如果配置了该选项,队列的大小是该队列)
注意:如果maxQueueSize=-1的话,则该选项不起作用
断路器
(1)hystrix.command.default.circuitBreaker.requestVolumeThreshold(当在配置时间窗口内达到此数量的失败后,进行短路。默认20个)
For example, if the value is 20, then if only 19 requests are received in the rolling window (say a window of 10 seconds) the circuit will not trip open even if all 19 failed.
简言之,10s内请求失败数量达到20个,断路器开。
(2)hystrix.command.default.circuitBreaker.sleepWindowInMilliseconds(短路多久以后开始尝试是否恢复,默认5s)
(3)hystrix.command.default.circuitBreaker.errorThresholdPercentage(出错百分比阈值,当达到此阈值后,开始短路。默认50%)
fallback
hystrix.command.default.fallback.isolation.semaphore.maxConcurrentRequests(调用线程允许请求HystrixCommand.GetFallback()的最大数量,默认10。超出时将会有异常抛出,注意:该项配置对于THREAD隔离模式也起作用)
五、属性配置参数
参数说明英文地址:https://github.com/Netflix/Hystrix/wiki/Configuration
(一)Command Properties
以下属性控制HystrixCommand行为:
1、Execution
以下属性控制HystrixCommand.run()如何执行。