本文介绍了如何通过wpa_supplicant和wpa_cli命令行工具连接Wi-Fi网络，包括无加密、WEP加密和WPA-PSK/WPA2-PSK加密的AP。步骤包括运行wpa_supplicant、使用wpa_cli设置网络参数，以及连接和验证连接状态。成功后，使用dhclient获取IP地址以接入互联网。
1: run wpa_supplicant first
use the following command:
wpa_supplicant -Dwext -iwlan0 -C/data/system/wpa_supplicant -c/data/misc/wifi/wpa_supplicant.conf
2: Run the command line tool wpa_cli to connect wifi
wpa_cli -p/data/system/wpa_supplicant -iwlan0
Then , it will let you set network interactively
some common command:
>scan = to scan the neighboring AP
>scan_results = show the scan results
>status = check out the current connection information
>terminate = terminate wpa_supplicant
>quit = exit wpa_cli
>add_network = it will return a network id to you
>set_network <network id> <variable> <value> = set network variables (shows list of variables when run without arguments), success will return OK, or will return Fail
>select_network <network id> = select a network (dis
use the following command:
wpa_supplicant -Dwext -iwlan0 -C/data/system/wpa_supplicant -c/data/misc/wifi/wpa_supplicant.conf
2: Run the command line tool wpa_cli to connect wifi
wpa_cli -p/data/system/wpa_supplicant -iwlan0
Then , it will let you set network interactively
some common command:
>scan = to scan the neighboring AP
>scan_results = show the scan results
>status = check out the current connection information
>terminate = terminate wpa_supplicant
>quit = exit wpa_cli
>add_network = it will return a network id to you
>set_network <network id> <variable> <value> = set network variables (shows list of variables when run without arguments), success will return OK, or will return Fail
>select_network <network id> = select a network (dis
最低0.47元/天 解锁文章
扫一扫
937
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
