[LabVIEW]DSB/SSB modulation and demodulation(单边带和双边带调制)

Introduction

In this lab, I know the principle of DSB/SSB modulation and demodulation and Hilbert transform. And I draw the LabVIEW program diagram for DSB/SSB modulation and demodulation. By observing and analyzing the performance of different signals in time domain and frequency domain, I have known the process of DSB/SSB modulation and demodulation. At the last of the lab, I use the knowledge of SSB modulation and demodulation to design a SSB walkie-talkie.

Lab results & Analysis：

1. The waveform compositions:

The compositions of waveform are t0, dt and y, the function of these three variables are:

1. t0 is the trigger time of the waveform.
2. dt is the time interval in seconds between data points in the waveform, we can also call dt as sampling frequency.
3. y is the data values of the waveform.

1. The Hilbert transformation:

The principle of Hilbert transform is taking a function, u(t) of a real variable and produces another function of a real variable H(u)(t). This linear operator is given by convolution with the function 1/ (πt).

And in the signal processing, Hilbert transform is still correct. I will show this result in the following figure:

Figure 1 The program diagram of verify Hilbert transform

Figure 2 The waveform of two signals

And in Figure 2, the waveform which was draw by red line is the signal that was get by Hilbert transform. And we can get that the red waveform has just 90-degree difference in phase with the white waveform.

1. The results of DSB modulation and demodulation:

First