在高通平台添加或者移植一个完整的camera

OV8865

1、kernel部分：

A、kernel_driver:

把驱动文件ov8865_qtech_f8865ac.c 放到kernel/drivers/media/platform/msm/camera_v2/sensor/目录下

B、kernel_dtsi:
把如下板级信息加到 kernel/arch/arm/boot/dts/msm8610-qrd-camera-sensor.dtsi文件中
actuator1: qcom,actuator@18 {
       cell-index = <4>;
       reg = <0x18>;
       compatible = "qcom,actuator";
       qcom,cci-master = <0>;
};
eeprom0:qom,eeprom@2b{
       cell-index = <0>;
       reg = <0x2b 0x0>;
...
...
       ｝；
qcom,camera@7f {
       compatible = "qcom,ov8865_qtech";
       reg = <0x7f>;
       qcom,slave-id = <0x6c 0x300b 0x8865>;
       qcom,csid-sd-index = <0>;
       qcom,actuator-src = <&actuator1>;
       qcom,eeprom-src = <&eeprom0>;
qcom,led-flash-src = <&led_flash0>;
       qcom,mount-angle = <90>;
       qcom,sensor-name = "ov8865_qtech";
cam_vdig-supply = <&pm8110_l7>;
cam_vana-supply = <&pm8110_l19>;
cam_vio-supply = <&pm8110_l14>;
qcom,cam-vreg-name = "cam_vdig", "cam_vio", "cam_vana";
qcom,cam-vreg-type = <0 0 0>;
qcom,cam-vreg-min-voltage = <1500000 1800000 2850000>;
qcom,cam-vreg-max-voltage = <1500000 1800000 2850000>;
qcom,cam-vreg-op-mode = <200000 200000 100000>;
qcom,gpio-no-mux = <0>;
gpios = <&msmgpio 13 0>,
<&msmgpio 21 0>,
<&msmgpio 20 0>,
                        <&pm8110_gpios 2 0>;
qcom,gpio-reset = <1>;
qcom,gpio-standby = <2>;
qcom,gpio-vdig = <3>;
qcom,gpio-req-tbl-num = <0 1 2 3>;
qcom,gpio-req-tbl-flags = <1 0 0 0>;
qcom,gpio-req-tbl-label = "CAMIF_MCLK",
"CAM_RESET1",