H3CNE 静态链路聚合

实验拓扑

---

实验需求

1.配置对应IP地址

2.在SW1,SW2的两条链路上配置链路聚合

3.SW1,SW2之间的聚合链路上配置为trunk类型，允许所有vlan通过

4.中断其中一条链路，查看聚合组的状态，并测试PC1和PC2是否能互通。

---

实验解法

一、配置对应IP地址

二、在SW1,SW2的两条链路上配置链路聚合

步骤一：创建一个聚合组

[SW1]int Bridge-Aggregation 1
[SW1-Bridge-Aggregation1]qu

[SW2]int Bridge-Aggregation 1
[SW2-Bridge-Aggregation1]qu

两边聚合组号可以不一致

步骤二：将对应接口加入到对应聚合组

[SW1]int range g1/0/1 g1/0/2
[SW1-if-range]port link-aggregation group 1

[SW2]int range g1/0/1 g1/0/2
[SW2-if-range]port link-aggregation group 1

三、聚合链路上配置为trunk类型，允许所有vlan通过

[SW1]int Bridge-Aggregation 1
[SW1-Bridge-Aggregation1]port link-type trunk 
[SW1-Bridge-Aggregation1]port trunk permit vlan all
[SW1-Bridge-Aggregation1]quit

[SW2]int Bridge-Aggregation 1
[SW2-Bridge-Aggregation1]port link-type trunk 
[SW2-Bridge-Aggregation1]port trunk permit vlan all
[SW2-Bridge-Aggregation1]qu

四、查看聚合组的状态

中断其中一条链路，查看聚合组状态

[SW2]int g1/0/1
[SW2-GigabitEthernet1/0/1]shutdown

PC1和PC2之间还是能通讯，所以证明链路聚合增加了链路的可靠性