关于n32g031芯片的串口初始化

风停了123

已于 2024-05-27 15:51:56 修改

阅读量207

点赞数 1

文章标签：单片机 mcu 嵌入式硬件

于 2024-05-27 15:39:17 首次发布

本文链接：https://blog.csdn.net/2301_79036162/article/details/139239853

版权

本代码为串口的输出与输入操作的代码初始化.

内容基本与stm32串口初始化一致.

#include "usart1.h"

void UART1_Init(void) {
    RCC_EnableAPB2PeriphClk(RCC_APB2_PERIPH_USART1, ENABLE);
		RCC_EnableAPB2PeriphClk(RCC_APB2_PERIPH_AFIO,  ENABLE);	

    GPIO_InitType GPIO_InitStruct1 = {0};
		GPIO_InitStruct(&GPIO_InitStruct1);
		GPIO_InitStruct1.Pin            =  GPIO_PIN_9 | GPIO_PIN_10;
    GPIO_InitStruct1.GPIO_Alternate = GPIO_AF4_USART1;
    GPIO_InitStruct1.GPIO_Mode      = GPIO_MODE_AF_PP;
    GPIO_InitPeripheral(GPIOA, &GPIO_InitStruct1);
		
    USART_InitType USART_InitStruct = {0};
		USART_InitStruct.BaudRate            = 115200;
    USART_InitStruct.WordLength          = USART_WL_8B;
    USART_InitStruct.StopBits            = USART_STPB_1;
    USART_InitStruct.Parity              = USART_PE_NO;
    USART_InitStruct.Mode                = USART_MODE_RX | USART_MODE_TX;
    USART_InitStruct.HardwareFlowControl = USART_HFCTRL_NONE;
    USART_Init(USART1, &USART_InitStruct);
		
		USART_ConfigInt(USART1,USART_INT_RXDNE,ENABLE);
		NVIC_InitType NVIC_InitStruct = {0};
		NVIC_InitStruct.NVIC_IRQChannel = USART1_IRQn;
		NVIC_InitStruct.NVIC_IRQChannelCmd = ENABLE;
		NVIC_InitStruct.NVIC_IRQChannelPriority = 3;
		NVIC_Init(&NVIC_InitStruct);
    USART_Enable(USART1, ENABLE);
}

int fputc(int ch, FILE *f)
{
	while(USART_GetFlagStatus(USART1, USART_FLAG_TXDE) != 1);//等待数据发完
	USART_SendData(USART1,ch);
	return ch;
}

void USART1_IRQHandler(void)
{
	uint8_t data1 = 0;
	if(USART_GetFlagStatus(USART1, USART_INT_RXDNE) == SET)
	{
		data1 = USART_ReceiveData(USART1);//库函数读
		USART1->DAT = data1;
//		USART_SendData(USART1,data1);
	}
	

}