VLAN实验

一，实验拓扑图及实验需求

二，分析实验需求并满足实验要求 

1.先创建VLAN2,3

[SW1]VLAN batch 2 3
/*batch意为创建多个VLAN*/
Info: This operation may take a few seconds. Please wait for a moment...done.
[SW1]
Jul 29 2024 13:35:50-08:00 SW1 DS/4/DATASYNC_CFGCHANGE:OID 1.3.6.1.4.1.2011.5.25
.191.3.1 configurations have been changed. The current change number is 5, the c
hange loop count is 0, and the maximum number of records is 4095.

 

为几个接口都分配vlan

[SW1]interface GigabitEthernet 0/0/3
[SW1-GigabitEthernet0/0/3]port link-type access 
[SW1-GigabitEthernet0/0/3]port default vlan 2
[SW1-GigabitEthernet0/0/4]port link-type access
[SW1-GigabitEthernet0/0/4]port default vlan 3
[SW1-GigabitEthernet0/0/2]port link-type access
[SW1-GigabitEthernet0/0/2]port trunk allow-pass vlan 2 3
/*总路干*/
[SW1-GigabitEthernet0/0/1]port link-type allow	
[SW1-GigabitEthernet0/0/1]port trunk allow-pass vlan 2 3
/*总路干*/

配置无误

 

 

 

 2.DHCP配置（创建池塘）

[AR1]dhcp enable
[AR1]ip pool vlan2
Info: It's successful to create an IP address pool.
[AR1-ip-pool-vlan2]network 192.168.2.0 mask 24
[AR1-ip-pool-vlan2]gateway-list 192.168.2.254
[AR1-ip-pool-vlan2]dns-list 8.8.8.8
[AR1-ip-pool-vlan2]quit
[AR1]ip pool vlan3
Info: It's successful to create an IP address pool.
[AR1-ip-pool-vlan3]network 192.168.3.0 mask 24
[AR1-ip-pool-vlan3]gateway-list 192.168.3.254
[AR1-ip-pool-vlan3]dns-list 8.8.8.8
[AR1-ip-pool-vlan3]
[AR1-ip-pool-vlan3]quit

注意：一般VLAN几IP地址后面就是几！

 

实验结果：

 

能够正常通讯 

 

 

实验成功，满足所有需求