HCIPMgre实验

1、实验拓扑如下：

二、实验要求：

 三、实验步骤：

1.按照拓扑划分的网段配置路由接口IP地址和缺省路由,以及主机的IP地址。

2.完成R1和R5直接的PAP认知。

3.完成R2与R5之间的chap认证。

4.完成R3与R5之间为HDLC封装。

5.私用网段配置NAT。

6.完成R1与R4为点到点GRE，完成R1/2/3构建MGRE。

7.基于RIP全网可达.

四、实验配置

R1：

[R1-Serial4/0/0]ppp pap local-user aa password cipher 123456
[R1]acl 2000
[R1-acl-basic-2000]rule permit source 192.168.1.0 0.0.0.255
[R1-acl-basic-2000]int s4/0/0
[R1-Serial4/0/0]nat outbound 2000
[R1]interface Tunnel 0/0/0   
[R1-Tunnel0/0/0]ip address 10.1.1.1 24    
[R1-Tunnel0/0/0]tunnel-protocol gre    
[R1-Tunnel0/0/0]source 15.1.1.1   
[R1-Tunnel0/0/0]destination 45.1.1.1
[R1]int Tunnel 0/0/1   
[R1-Tunnel0/0/1]ip address 10.1.2.1 24 
[R1-Tunnel0/0/1]tunnel-protocol gre p2mp
[R1-Tunnel0/0/1]source 15.1.1.1  
[R1-Tunnel0/0/1]nhrp entry multicast dynamic    
[R1-Tunnel0/0/1]nhrp network-id 100
[R1]rip 1
[R1-rip-1]version 2    
[R1-rip-1]undo summary    
[R1-rip-1]network 192.168.1.0
[R1-rip-1]network 10.0.0.0
[R1]interface Tunnel 0/0/1   
[R1-Tunnel0/0/1]undo rip split-horizon

R2:

R2-Serial4/0/0]ppp chap user aa ppp chap password cipher 123456
[R2]acl 2000
[R2-acl-basic-2000]rule permit source 192.168.2.0 0.0.0.255
[R2-acl-basic-2000]int s4/0/0
[R2-Serial4/0/0]nat outbound 2000
[R2]interface Tunnel 0/0/1
[R2-Tunnel0/0/1]ip address 10.1.2.2 24
[R2-Tunnel0/0/1]tunnel-protocol gre p2mp   
[R2-Tunnel0/0/1]source Serial 4/0/0    
[R2-Tunnel0/0/1]nhrp network-id 100  
[R2-Tunnel0/0/1]nhrp entry 10.1.2.1 15.1.1.1 register 
[R2]rip 1
[R2-rip-1]version 2    
[R2-rip-1]undo summary    
[R2-rip-1]network 192.168.2.0
[R2-rip-1]network 10.0.0.0

R3:

[R3-Serial4/0/0]link-protocol hdlc
[R3]acl 2000
[R3-acl-basic-2000]rule permit source 192.168.3.0 0.0.0.255
[R3-acl-basic-2000]int s4/0/0
[R3-Serial4/0/0]nat outbound 2000
[R3]interface Tunnel 0/0/1    
[R3-Tunnel0/0/1]ip address 10.1.2.3 24  
[R3-Tunnel0/0/1]tunnel-protocol gre p2mp    
[R3-Tunnel0/0/1]source Serial 4/0/0  
[R3-Tunnel0/0/1]nhrp network-id 100    
[R3-Tunnel0/0/1]nhrp entry 10.1.2.1 15.1.1.1 register 
[R3]rip 1
[R3-rip-1]version 2    
[R3-rip-1]undo summary    
[R3-rip-1]network 192.168.3.0
[R3-rip-1]network 10.0.0.0

R4:

[R4]acl 2000
[R4-acl-basic-2000]rule permit source 192.168.1.0 0.0.0.255
[R4-acl-basic-2000]int g0/0/0
[R4-GigabitEthernet0/0/0]nat outbound 2000
[R4]interface Tunnel 0/0/0  
[R4-Tunnel0/0/0]ip address 10.1.1.2 24   
[R4-Tunnel0/0/0]tunnel-protocol gre 
[R4-Tunnel0/0/0]source 45.1.1.1
[R4-Tunnel0/0/0]destination 15.1.1.1
[R4]rip 1
[R4-rip-1]version 2    
[R4-rip-1]undo summary    
[R4-rip-1]network 192.168.4.0
[R4-rip-1]network 10.0.0.0

ISP：

[ISP-Serial1/0/1]ppp authentication-mode chap
[ISP-Serial2/0/0]link-protocol hdlc 

五、PC1可以ping通ISP的环回。

 

R1与R4为点到点GRE：

R1\R2\R3构建一个MGRE：

 

 

最后可以实现全网可达：