1.gedit /etc/network/interfaces
add the content:
auto lo
iface lo inet loopback
iface eth0 inet static
address 192.168.0.12
netmask 255.255.255.0
gateway 192.168.0.1
auto eth0
2.gedit /etc/resolv.conf
add the content:
# Generated by NetworkManager
nameserver 192.168.0.1 # it depends
3. /etc/init.d/networking restart
when install ubuntu in vmare, choose the NAT conection. after you finish install the ubuntu , it is not necessary to configure the net.
//
<!-- @page { margin: 2cm } P { margin-bottom: 0.21cm } -->
# ifconfig eth1 192.168.1.100 netmask 255.255.255.0 up # ifconfig eth1 eth1 Link encap:Ethernet HWaddr 00:21:85:6b:c1:ad inet addr:192.168.1.100 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) Interrupt:18