本文汇总了Xprog-M盒ECU编程器用户在软件操作中遇到的问题及其解决方法。包括'Access violation'错误、提示更新固件、读取串行EEPROM失败等问题，提供了详细的操作建议和下载链接。
Here, have collected the solutions for software operation problems from Xprog-M box ECU programmer users.
- Problem: The xprog V5.84 shows “Access violation at address 00478FC6 in module “XProgDesktop.dll”. Read of address 00000358.”
Solution: Check if the anti-virus software has been installed in the computer. If have, please close it, because the anti-virus software
will kill xprog-M driver. Then open the xprog V5.84 again. If it also doesn’t work, try to unzip xprog software again.
- Problem: It always prompts “This program version requires to update the XPROG firmware. Do you want to update now?” when using xprog -M box.
Solution: Please check if you connect the internet, if it is, disconnect the internet. Never try to UPDATE, the hardware will be damaged if
you want to try to update it online, then you will lose its warranty.
- Problem: My Xprog V5.84 fail to read serial eeprom, don
最低0.47元/天 解锁文章
扫一扫
1245
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
