DS200TCOBG1AEB燃机卡

产品标题: DS200TCOBG1AEB燃机卡

型号：DS200TCOBG1AEB

品牌：GE

                                                              产品详情资料：

通道状态数据的参考地址%I参考类型标准范围%I00001的起始地址，或下一个可用地址长度%I状态位置的数量8或16 8当模块从RUN（运行）切换到Stop（停止）模式保持***状态或默认为零保持***状态输出通道范围类型输出范围0，+10V-10，+10V 4，20 mA 0，20 mA活动通道表示PLC CPU将扫描的通道数量。对停止模式所做的选择决定了当从运行模式转到停止模式时，模块的输出是保持其***状态还是默认为零。%AQ参考地址参数选择%AQ内存中将开始向模块输出数据的区域的起始位置。参考地址选择%I内存中模块状态数据区域的起始位置。如果长度设置为8，则只报告模块状态。如果长度设置为16，则还将报告作为电流输出运行的信道的信道状态。每个通道可设置为在四个输出范围之一上运行：? 0至10 V（默认值? -10至+10 V范围? 4至20 mA和0至20 mA? 0至20毫安

                                                            产品英文详情料:

Reference Address for Channel Status Data tarting address for %I reference type standard range %I00001, or next highest available address Length Number of %I status locations 8 or 16 8 Stop Mode Output state when module toggled from RUN to STOP mode Hold Last State or Default to Zero Hold Last StateOutput Channel Range Type of Output Range 0, +10V -10, +10V 4, 20 mA 0, 20 mA Active Channels indicates the number of channels that will be scanned by the PLC CPU. The choice made for Stop Mode determines whether the module’s outputs will hold their last states or default to zero when the goes from Run to Stop mode. The %AQ Reference Address parameter selects the start of the area in the %AQ memory where the output data to the module will begin. The %I Reference Address selects the start of the area in %I memory for the module’s status data. If the length is set to 8, then only module status will be reported. If the length is set to 16, channel status will also be reported for channels that are operating as current outputs. Each channel can be set up to operate on one of four output ranges: ? 0 to 10 V (default ? -10 to +10 V range ? 4 to 20 mA, and 0 to 20 mA ? 0 to 20 mA