Модуль 3500/46-03-00 Bently 电子超速检测系统

                                                                         产品详情资料：

BENTLY 3500/32工业显示屏使用数据设置为所需值。所有其他参数都不需要更改。表3中标有*的参数在下载过程中根据从设备的实际配置自动计算。自动计算可确保所有计算参数均处于安全侧。这意味着还必须考虑手动更改。因此，实际设置不会朝着更快但不安全的值的方向改变。要获得PROFIBUS主参数的优化值，请将参数计算方法设置为基于***小值。自动计算现在将重新计算所有参数。结果是您可以为已配置的从机达到的***快周期时间。

在主机对主机通信的情况下，此参数***请求者获取响应所需的***长时间。所有波特率的默认值为50 ms。总线参数标志定义了CI854/CI854A对故障的反应方式。“自动清除开启”时，仅一个从机的单一故障将使主机进入清除状态：CI854/CI854A读取从机的输入信息，并将从机的输出保持在故障安全状态（“0”输出）。“自动清除关闭”时，通信将继续与从属设备而不是受干扰的从属设备运行。请参阅第23页的系统行为。自动清除模式可能会重置输出，从而关闭系统。默认为“自动清除关闭”。仅在需要时启用此功能。

                          产品英文详情资料：

to the required values. All other parameters don’t need to be changed. The Parameters marked with a * in Table 3 are calculated automatically during download depending on the actual configuration for the slave units. The automatic calculation ensures that all calculated parameters will be on the safe side. This means also manual changes have to be considered. Therefore no changes of the actual settings in direction to faster but insecure values takes place. To get the optimized values for the PROFIBUS master parameters set the parameter Calculation method to Minimum value based. The automatic calculation will now recalculate all parameters. The result is the fastest possible cycle time you can reach for the configured slaves.

In the case of master-to-master communication this parameter specifies the maximum amount of time the requester may take to fetch the response. The default for all baud rates are 50 ms.Bus parameter flag that defines how the CI854/CI854A shall react on a failure. With “Auto Clear ON” a single failure of only one slave will bring the master into the clear state: the CI854/CI854A reads the input information of the slaves and keeps the outputs of the slaves in a fail-safe state (“0” output). With “Auto Clear OFF” the communication will keep running with the slaves instead of the disturbed one. Please refer also to System Behavior on page 23. The Auto Clear Mode may reset your outputs and therefore shutdown your system. The default is “Auto Clear OFF”. Enable this functionality only in cases when it’s needed.